Whirlpool 3RAWZ480E 사용 및 관리 매뉴얼 - 페이지 14

{카테고리_이름} Whirlpool 3RAWZ480E에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3RAWZ480E 28 페이지. Electric and gas dryer
Whirlpool 3RAWZ480E에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (24 페이지), 설치 지침 매뉴얼 (21 페이지)

페이지 인쇄

1. Parts and Features

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor

for a garage installation.

Failure to do so can result in death, explosion, or fire.

Is the dryer located in a room with temperature below

7ºC (45ºF)?

Proper operation of dryer cycles requires temperatures above

7ºC (45ºF).

Is the dryer located in a closet?

Closet doors must have ventilation openings at the top and

bottom of the door. The rear of the dryer requires 14 cm (5½")

of airspace, and 2.5 cm (1") is recommended for the sides

and front of the dryer. See the Installation Instructions.

Has an air dry cycle been selected?

Select the right cycle for the types of garments being dried.

See "Cycles."

Is the load too large and heavy to dry quickly?

Separate the load to tumble freely.

Before calling for assistance or service, please check the

"Troubleshooting" section. It may save you the cost of a service

call. If you still need help, follow these instructions.

If you need assistance or service

If your problem is not due to any of the items listed in the

"Troubleshooting" section, contact the dealer from whom you

purchased the dryer, or a designated Whirlpool service company.

When calling, please know the purchase date, and the complete

model and serial number of your appliance. This information will

help us better respond to your request.

ASSISTANCE OR SERVICE

Lint on load

Is the lint screen clogged?

Lint screen should be cleaned before each load.

Stains on load or drum

Was dryer fabric softener properly used?

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can

stain your garments.

Drum stains are caused by dyes in clothing (usually blue

jeans). This will not transfer to other clothing.

Loads are wrinkled

Was the load removed from dryer at the end of the cycle?

Was the dryer overloaded?

Dry smaller loads that can tumble freely.

Odors

Have you recently been painting, staining or varnishing in

the area where your dryer is located?

If so, ventilate the area. When the odors or fumes are gone

from the area, rewash and dry the clothing.

Is the dryer being used for the first time?

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

For further assistance

If you need further assistance, you can write or call with any

questions or concerns at:

Whirlpool UK Ltd.

209 Purley Way

Croydon

CR9 4RY

U.K.

Telephone: 0208 649 5000