Whirlpool 3RLEC8646 사용 및 관리 매뉴얼 - 페이지 6

{카테고리_이름} Whirlpool 3RLEC8646에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3RLEC8646 12 페이지. Electric and gas dryers
Whirlpool 3RLEC8646에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (8 페이지)

페이지 인쇄

CHECKING

YOUR VENT

Your dryer must be properly installed and vented to achieve

maximum drying efficiency and shorten drying times. Use the

minimum recommended installation clearances (found in your

Installation Instructions) to avoid blocking the flow of combustion

and ventilation air. Refer to your Installation Instructions for more

information.

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in

death or fire.

If the dryer is not properly installed and vented, it will not be

covered under the warranty.

NOTE: Service calls caused by improper venting will be paid for

by the customer, whether it was a paid installation or self-

installed.

1. Do not use plastic vent or metal foil vent. Use a 10.2 cm

(4 in.) metal or flexible metal vent. Do not kink or crush

flexible metal vent. It must be completely extended to allow

adequate exhaust air to flow. Check vent after installation.

Refer to your Installation Instructions for proper length

requirements of vent.

2. Use a 10.2 cm (4 in.) exhaust hood. Smaller hoods increase

drying times.

10,2 cm

(4")

3. The exhaust vent can be routed up, down, left, right, or

straight out the back of the dryer. Space requirements are

listed in your Installation Instructions.

4. Use the straightest path possible when routing the exhaust

vent. Use the fewest number of elbows and turns. Allow

room when using elbows or making turns. Bend vent

gradually to avoid kinking.

5. Use duct tape to seal all joints. Do not use screws to secure

vent. Lint may catch on screws.

6. Clean exhaust vent periodically, depending on use, but at

least every 2 years, or when installing your dryer in a new

location.

Disconnect vent from the dryer and clean one section at a

time until you reach the exhaust hood.

To clean out lint, use the hose attachment on your

vacuum, or a pole or wire with a feather duster or rag

attached.

Be sure the flapper on the outside end of vent moves

freely.

When cleaning is complete, be sure to follow the

Installation Instructions supplied with your dryer for final

product check.