Whirlpool 3RLEQ8000 사용 및 관리 매뉴얼 - 페이지 10

{카테고리_이름} Whirlpool 3RLEQ8000에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3RLEQ8000 12 페이지. Electric and gas dryers
Whirlpool 3RLEQ8000에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (8 페이지)

페이지 인쇄

Regular Servicing

To keep your dryer operating at highest efficiency, regular

servicing by a designated Whirlpool service technician is

recommended. For normal use, this servicing should be at

12 monthly intervals. For heavy-duty usage, this interval should

be reduced accordingly.

Vacation and Moving Care

Vacation care

Operate your dryer only when you are at home. If you will be on

vacation or not using your dryer for an extended period of time,

you should:

1. Unplug dryer or disconnect power.

2. If you have a gas dryer, close shutoff valve in gas supply line.

3. Clean lint screen. See "Cleaning the Lint Screen."

Moving care - Electric Dryers

For power supply cord-connected dryers:

1. Unplug the power supply cord.

2. Make sure leveling legs are secure in dryer base.

3. Use masking tape to secure dryer door.

First try the solutions suggested here and possibly avoid the cost of a service call...

Dryer Operation

Dryer will not run

Has a household fuse blown, or has a circuit breaker

tripped?

There may be 2 household fuses or circuit breakers for the

dryer. Check to make sure both fuses are intact and tight, or

that both circuit breakers have not tripped. Replace the fuse

or reset the circuit breaker. If the problem continues, call an

electrician.

Is the correct power supply available?

Electric dryers require 240 volt power supply. Check with a

qualified electrician.

Was a regular fuse used?

Use a time-delay fuse.

Is the dryer door firmly closed?

Was the Push to Start button firmly pressed?

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

For direct-wired dryers:

1. Disconnect power.

2. Disconnect wiring.

3. Make sure leveling legs are secure in dryer base.

4. Use masking tape to secure dryer door.

Moving care - Gas Dryers

1. Unplug the power supply cord.

2. Close shutoff valve in gas supply line.

3. Disconnect gas supply line pipe and remove fittings attached

to dryer pipe.

4. Cap the open fuel supply line.

5. Make sure leveling legs are secure in dryer base.

6. Use masking tape to secure dryer door.

TROUBLESHOOTING

No heat

Has a household fuse blown, or has a circuit breaker

tripped?

Electric dryers use 2 household fuses or circuit breakers. The

drum may be turning, but you may not have heat. Replace the

fuse or reset the circuit breaker. If the problem continues, call

an electrician.

For gas dryers, is the valve open on the supply line?

Unusual sounds

Has the dryer had a period of non-use?

If the dryer hasn't been used for a while, there may be a

thumping sound during the first few minutes of operation.

Is a coin, button, or paper clip caught between the drum

and front or rear of the dryer?

Check the front and rear edges of the drum for small objects.

Clean out pockets before laundering.

WARNING

Electrical Shock Hazard