Whirlpool 3SWED5205SQ1 사용 및 관리 매뉴얼 - 페이지 23

{카테고리_이름} Whirlpool 3SWED5205SQ1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3SWED5205SQ1 24 페이지. Electronic dryer

페이지 인쇄

TROUBLESHOOTING

First try the solutions suggested here to possibly avoid the cost of a service call.

If you experience

Timer does not

advance

Cycle time too short

Lint on load

Stains on load or drum

Loads are wrinkled

Odors

Possible Causes

Dryer not set to Timed Drying or

Air Dry (depending on model).

Dryer not set to Automatic Dry.

Automatic cycle ending early.

Lint screen clogged.

Improper use of dryer sheets.

Loose dyes in clothes.

Load not removed from dryer at the

end of the cycle.

Dryer tightly packed.

Recent painting, staining, or

varnishing in the area where your

dryer is located.

Dryer being used for the first time.

The timer moves slowly and continuously for the time setting.

The times moves only when the clothing is mostly dry. See

"Setting the Drying Temperature" under Cycle Guide.

The load may not be contacting the sensor strips. Level the

dryer.

Use Timed Dry for very small loads. Change the dryness level

setting on Automatic Cycles. Increasing or decreasing the

dryness level will change the amount of drying time in a cycle.

Lint screen should be cleaned before each load.

Add dryer sheets at the beginning of the cycle. Dryer sheets

added to a partially dried load can stain your garments.

Drum stains are caused by dyes in clothing (usually blue jeans).

These will not transfer to other clothing.

Select Wrinkle Shield feature to tumble the load without heat

to avoid wrinkling.

Dry smaller loads that can tumble freely reduce wrinkles from

forming.

Ventilate the area. When the odors or fumes are gone from

the area, rewash and dry the clothing.

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

Solution