Whirlpool 4KNED4400 사용 및 관리 매뉴얼 - 페이지 12

{카테고리_이름} Whirlpool 4KNED4400에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 4KNED4400 36 페이지.

페이지 인쇄

TROUBLESHOOTING cont.

First try the solutions suggested here to possibly avoid the cost of a service call.

if you experience

Possible

Causes

Solution

Cycle time too short

Automatic

Dry cycle ending early.

Lint on load

Stains on load or drum

Lint screen clogged.

Dryer fabric softener not properly

used.

Loads are wrinkled

Load not removed from dryer at the

end of the cycle.

Dryer tightly packed.

Odors

Have you recently been painting,

staining, or varnishing in the area

where your dryer is located?

Is the electric dryer being used for

the first time?

Load is too hot

Were laundry items removed from

the dryer before the end of the

cycle?

Was a high temperature

cycle

used or was TEMPERATURE

control set to high?

The load may not be contacting

the sensor strips. Level the

dryer.

Use Timed Dry for very small loads. Change the Dry Level

setting on Automatic

Dry cycles.

Increasing or decreasing the Dry Level setting will change the

amount of drying time in a cycle.

Lint screen should be cleaned before each load.

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can stain

your garments.

Drum stains are caused by dyes in clothing (usually blue jeans).

These will not transfer to other clothing.

Select Wrinkle Prevent option to tumble the load without heat

to avoid wrinkling.

Dry smaller loads that can tumble freely reduce wrinkles from

forming.

If so, ventilate the area. When the odors or fumes are gone

from the area, rewash and dry the clothing.

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

Allow Cool Down cycle to finish before removing laundry from

dryer. All cycles are cooled slowly to reduced wrinkling and

make it easier to handle. Items removed before Cool Down

may feel very warm.

Select a lower temperature,

and use an automatic drying cycle.

These cycles sense the temperature

or the moisture level in the

load and shut off when the load reaches the selected dryness.

This reduces overdrying,