Whirlpool 7MWED2040 설치 지침 매뉴얼 - 페이지 27
{카테고리_이름} Whirlpool 7MWED2040에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7MWED2040 44 페이지. Electric/gas dryer
Whirlpool 7MWED2040에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (32 페이지)
페이지 인쇄
Installation Requirements
Tools and Parts
Gather required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Wire stripper
1/4" nut driver
(recommended)
Adjustable wrench that
opens to 1" or hex-head
socket wrench
Ruler or measuring tape
Level
Putty knife
#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent Clamps
Utility knife
Pliers
Caulking gun and compound
(for installing new exhaust vent)
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to propane gas
Parts supplied:
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts are
included.
Parts needed:
Check local codes. Check existing electrical supply and venting,
and read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Mobile home installations require metal exhaust system
hardware, available for purchase from the dealer from whom you
purchased your dryer. For further information, please refer the
"Assistance or Service" section of the "Use and Care Guide".
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
■ UL listed 30 A power supply cord, rated 120/240 V minimum.
The cord should be type SRD or SRDT and be at least
4 ft. (1.22 m) long. The wires that connect to the dryer must
end in ring terminals or spade terminals with upturned ends.
■ A UL listed strain relief.
Optional Equipment:
(Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
8" or 10" adjustable wrench
(for gas connections)
27