Whirlpool 7MWED2040 설치 지침 매뉴얼 - 페이지 42

{카테고리_이름} Whirlpool 7MWED2040에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7MWED2040 44 페이지. Electric/gas dryer
Whirlpool 7MWED2040에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (32 페이지)

페이지 인쇄

Complete Installation

Checklist

Check that all parts are now installed. If there is an extra part,

go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Check dryer's final location. Be sure vent is not crushed

or kinked.

For power supply cord installation, plug into an outlet.

For direct wire installation, turn on power.

Check that dryer is level. See "Level Dryer".

Remove film on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

Read "Dryer Use" in your "Use and Care Guide".

Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

For Electric Dryers:

If the dryer will not start, check the following:

■ Controls are set in a running or "On" position.

■ Start button has been pushed firmly.

■ Dryer is plugged into an outlet and/or electrical supply is

on.

■ Household fuse is intact and tight, or circuit breaker has

not tripped.

■ Dryer door is closed.

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, turn off dryer, and check the

following:

■ There may be 2 household fuses or circuit breakers for the

dryer. Check that both fuses are intact and tight, or that

both circuit breakers have not tripped. If there is still no

heat, contact a qualified technician.

NOTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used. The

odor will go away.

For Gas Dryers:

If the dryer will not start, check the following:

■ Dryer is plugged into a grounded 3-prong outlet.

■ Electrical supply is connected.

■ Household fuse is intact and tight, or circuit breaker has

not tripped.

■ Dryer door is closed.

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, turn the dryer off and check to see

whether gas supply line shut-off valve is open.

■ If the gas supply line shut-off valve is closed, open it, then

repeat the 5-minute test as outlined above.

■ If the gas supply line shut-off valve is open, contact a

qualified technician.

NOTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used. The

odor will go away.