Whirlpool 7MWED2140 설치 지침 매뉴얼 - 페이지 36

{카테고리_이름} Whirlpool 7MWED2140에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7MWED2140 44 페이지. Electric/gas dryer
Whirlpool 7MWED2140에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (32 페이지)

페이지 인쇄

Connect neutral ground wire and

neutral wire

Connect neutral ground wire (E) and neutral wire (white or

center wire) (C) of power supply cord or cable under center

terminal block screw (B). Tighten screw.

Connect remaining wires

Place hooked ends of remaining wires under outer terminal

block screws (hooks facing right). Tighten screws.

Connect external ground wire

Connect a separate copper ground wire (G) from the external

ground conductor screw (A) to an adequate ground. Finally,

reinsert tab of terminal block cover into slot of dryer rear panel.

Secure cover with hold-down screw. Now, go to Venting

Requirements.

Gas Dryer Power Hookup

Gas Supply Requirements

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to propane, have a qualified person make

sure gas pressure does not exceed 13" (330 mm) water

column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and

authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Gas Type

Natural Gas:

This dryer is equipped for use with natural gas. It is certified by

UL for use with propane gas with appropriate conversion.

■ Your dryer must have the correct burner for the type

of gas in your home. Burner information is located on the

rating plate in the door well of your dryer. If this information

does not agree with the type of gas available, please refer the

"Assistance or Service" section of the "Use and Care Guide."

Propane Gas Conversion:

Conversion must be made by a qualified technician.

No attempt shall be made to convert the dryer from the gas

specified on the model/serial rating plate for use with a different

gas without consulting the serving gas supplier.

IMPORTANT: The gas installation must conform with local codes,

or in the absence of local codes, with the National Fuel Gas

Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and

Propane Installation Code, CSA B149.1.

Gas supply line

■ 1/2" NPT pipe is recommended.

■ 3/8" approved tubing is acceptable for lengths under

20 ft. (6.1 m) if local codes and gas supplier permit.

■ Must include 1/8" NPT minimum plugged tapping accessible

for test gauge connection, immediately upstream of the gas

connection to the dryer (see illustration).

■ Must include a shut-off valve:

In the U.S.A.:

An individual manual shut-off valve must be installed within

six (6) feet (1.8 m) of the dryer in accordance with the National

Fuel Gas Code, ANSI Z223.1.