Whirlpool 7MWGD1730 설치 지침 매뉴얼 - 페이지 41

{카테고리_이름} Whirlpool 7MWGD1730에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7MWGD1730 44 페이지. Electric/gas dryer
Whirlpool 7MWGD1730에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (32 페이지)

페이지 인쇄

Plan pipe fitting connection

B. 3/8" dryer pipe

A combination of pipe fittings must be used to connect dryer

to existing gas line. A recommended connection is shown.

Your connection may be different, according to supply line

type, size, and location.

Open shut-off valve

Closed valve

Open shut-off valve in supply line; valve is open when handle

is parallel to gas pipe. Then, test all connections by brushing

on an approved noncorrosive leak-detection solution. Bubbles

will show a leak. Correct any leaks found.

Connect Vent

Connect vent to exhaust outlet

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fit over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 4" (102 mm) clamp.

C. 3/8" to 3/8" pipe elbow

Open valve

Move dryer to final location

Move dryer to final location. Avoid crushing or kinking vent.

After dryer is in place, remove corner posts and cardboard

from under the dryer.

Level Dryer

Level the dryer

Check levelness of dryer from side to side. Repeat from

front to back.

NOTE: The dryer must be level for the moisture sensing

system to operate correctly.

Not Level

Tighten and adjust leveling legs

If dryer is not level or the same height as the washer, prop up

using a wood block. Use wrench to adjust legs up or down,

and check again for levelness. Once legs are level, make sure

all four legs are snug against the floor before tightening them.

LEVEL

Not Level