Whirlpool 8314832A 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool 8314832A에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8314832A 28 페이지. Electric and gas dryers

페이지 인쇄

Fluff Air cycle or Air Only setting

Use the Fluff Air cycle, or Air Only setting, for items that require

drying without heat such as rubber, plastic and heat sensitive

fabrics. Set the Cycle Control k nob to Fluff Air or select Air Only

on the Temperature selector and set the Cycle Control k nob to

Timed Drying. This chart shows examples of items that can be

dried using the Fluff Air cycle/Air Only setting.

Type of Load

Foam rubber - pillows, padded bras,

stuffed toys

Plastic - Shower curtains, tablecloths

Rubber-back ed rugs

Olefin, polypropylene, sheer nylon

*(Minutes). Reset cycle to complete drying, if needed.

When using Fluff Air or Air Only

Check to see that coverings are securely stitched.

Shak e and fluff pillows by hand periodically during cycle.

Dry item completely. Foam rubber pillows are slow to dry.

Additional Features

This manual covers several different models. Your dryer may not

have all of the features described.

Towels

Select this setting to thoroughly dry extra heavy items such as

mattress pads and quilts or a load of towels. Set the temperature

selector, if available, to High Heat.

WRINKLE SHIELD™ feature

When you are unable to remove a load from the dryer as soon as

it stops, wrink les can form. The WRINKLE SHIELD feature

periodically tumbles, rearranges and fluffs the load without heat

to avoid wrink les. A signal will sound periodically when the

WRINKLE SHIELD feature is on, if the End of Cycle Signal is

selected. The signal and the tumbling will end when you open the

dryer door or turn the Cycle Control k nob to Off.

Your model may vary from the model shown.

Your dryer may have one of the following features:

WRINKLE SHIELD (automatic)

WRINKLE SHIELD setting automatically activates at the end

of the cycle if you do not open the dryer door within a few

minutes. WRINKLE SHIELD setting periodically tumbles the

load without heat for up to 45 minutes.

WRINKLE SHIELD (optional)

Turn the WRINKLE SHIELD setting to On to periodically

tumble the load without heat up to 45 minutes after the cycle

ends.

WRINKLE SHIELD™ PLUS 30/90 Minute

The WRINKLE SHIELD PLUS setting lets you choose 30 or 90

minutes of periodic unheated tumble after the cycle ends.

Fluff Air cycle/

Heavy Dry

Air Only setting*

Select this setting to evenly dry large or heavy items such as

thick cotton bath towels or robes. Set the Temperature selector, if

available, to High Heat.

20 - 30

DRYEL

40 - 50

When using DRYEL fabric care, select the DRYEL cycle setting

and the DRYEL temperature setting. DRYEL fabric care, when

10 - 20

used in accordance with the manufacturer's directions, has been

tested and approved for use in full-size dryers built by Whirlpool

Corporation.

Damp Dry

Select this setting to dry items to a damp level, or to dry items

that do not require an entire drying cycle. Damp dry items such

as jeans (to prevent stiffness) or cotton clothing (to mak e

pressing easier). Set the temperature selector, if available, to High

Heat.

TUMBLE PRESS

Select this setting to remove wrink les from items such as clothing

pack ed in a suitcase or items wrink led from being left in the dryer

too long. Set the temperature selector, if available, to Medium or

Low Heat depending on the fabrics in your load.

End of Cycle Signal

If your model has an End of Cycle Signal, the signal sounds

when a cycle is complete. If the WRINKLE SHIELD™ feature is

on, the signal sounds every few minutes. The signal stops when

you open the door or turn the Cycle Control k nob to Off.

On some models

The End of Cycle Signal is fixed.

The End of Cycle Signal is selectable. The signal will sound

only if the signal is set to On.

fabric care system

setting