Whirlpool 8527902 설치 지침 매뉴얼 - 페이지 11
{카테고리_이름} Whirlpool 8527902에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8527902 25 페이지. Commercial electronic dryer
페이지 인쇄
Three-wire connection...
Three-wire
receptacle
Where local codes Do Not permit
connecting
cabinet-ground
conductor
to neutral wire:
4.
Remove center terminal block
screw.
9.
After
reaftaching
the terminal
cover,
connect
a separate
copper
ground
wire from the external
ground
connector
screw
to an
adequate
ground.
5. Remove
the appliance
harness
ground
wire (green
with yellow
\
stripes)
from the external
ground
connector
screw.
Connect
appliance
harness
ground
wire and
the neutral
wire (white
or center)
of
the power
supply
cord/cable
under
the center,
silver-colored
terminal
block
screw.
Tighten
screw.
=
terminal block screws. Tighten
screws.
7. Tighten strain relief screws. _
"
"_
8.
Insert tab of terminal block cover
into slot of dryer rear panel. Secure
cover with hold-down
screw.
mTo exhaust dryer, see Exhaust
requirements,
Pages 3-4, Connect
exhaust vent to dryer exhaust outlet
and exhaust hood using 4" (10,2 cm)
clamps,
Use caulking
to seal exterior
wall opening
around
exhaust hood,
m Carefully
move
dryer into final
position,
Place level on top of the
dryer, first side to side; then front to
back, If the dryer is not level, adjust
the legs of the dryer up or down
until
the dryer is level,
m Plug power supply cord
into
grounded
outlet or connect
direct
wire to power supply,
Turn power supply on,
0m
Check dryer operation
(some
accumulated
time may be on the
timer due to factory
testing),
Pull timer-set
bufton
left, (Operating
time will accumulate
per number
of
depressions
and Iype of timing cam
used,) Push START/RESTART bufton,
Using a full heat cycle
(not the air
cycle),
let the dryer run for at least
five minutes,
Note: Dryer door must be closed for
dryer to operate,
When door is open,
dryer stops, but timer continues
to run,
To restart dryer, close door and push
START/RESTARTbufton,
1
• If drying time is too long,
make sure lint screen is clean,
2m
Now start the dryer and allow
it to complete
a full heat cycle
(not
air cycle)
to make sure it is working
properly,
Page 11