Whirlpool 8535839 사용 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool 8535839에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8535839 28 페이지. Resource saver electric and gas dryers

DRYER USE

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Do not dry anything that has ever had anything

flammable on it (even after washing).

Failure to follow these instructions can result in

death, explosion, or fire.

Fire Hazard

No washer can completely remove oil.

Do not dry anything that has ever had any type of

oil on it (including cooking oils).

Items containing foam, rubber, or plastic must be

dried on a clothesline or by using an Air Cycle.

Failure to follow these instructions can result in

death or fire.

Before using your dryer, wipe the dryer drum with a damp cloth to

remove dust from storing and shipping. The following steps

provide an overview for operating your dryer. Specific directions

for each step are provided in the following sections.

1. Load clothes loosely into the dryer and close the door. Do not

pack the dryer. Allow space for clothes to tumble freely.

2. Turn the Cycle Control knob to the recommended cycle for

the type of load being dried. Use the Energy Preferred Setting

to dry most loads. See "Drying, Cycle and Temperature Tips."

3. Select a Temperature setting. See "Temperature Settings."

4. (OPTIONAL STEP) Set the WRINKLE SHIELD™ Plus selector

to the desired setting. See "Additional Features."

5. (OPTIONAL STEP) Set the End of Cycle Signal to the desired

setting. The signal is helpful when drying permanent press or

synthetics. Promptly remove these items from the dryer at the

end of the cycle to prevent wrinkles.

6. Push the PUSH TO START button.

You can stop your dryer any time during a cycle.

To stop your dryer

Open the dryer door or turn the Cycle Control knob to OFF.

NOTE: The Cycle Control knob should point to an Off area when

the dryer is not in use.

To restart your dryer

1. Close the door.

2. Select a new cycle and temperature (if desired).

3. Push START.