Whirlpool 8578902A 사용 및 관리 매뉴얼 - 페이지 5

{카테고리_이름} Whirlpool 8578902A에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8578902A 48 페이지. Electronic gas dryer

페이지 인쇄

For close-clearance installations between 28.65" (72.77 cm)

and 34.15" (86.74 cm), see "Plan Vent System" section for

venting requirements.

Mobile home installations require special parts (listed following)

that may be ordered by calling the dealer from whom you

purchased your dryer. For further information, please refer to the

"Assistance or Service" section of this manual.

Mobile Home Installation Kit. Ask for Part Number 346764.

Metal exhaust system hardware.

Optional Pedestal

Are you placing the dryer on a pedestal? You have the option of

purchasing pedestals of different heights separately for this dryer.

You may select a 10" (25.4 cm) pedestal or a 15.5" (39.4 cm)

pedestal with a shelf and bin dividers. These pedestals will add to

the total height of the dryer for a total height of approximately

46" (116.8 cm) or 51.5" (130.8 cm).

For a garage installation, you will need to place the dryer at least

18" (46 cm) above the floor.

Optional pedestal (15.5" [39.4 cm] model shown)

To order, call the dealer from whom you purchased your dryer or

refer to the "Assistance or Service" section of this manual.

Pedestal

Height

10" (25.4 cm)

15.5" (39.4 cm) with

shelf and bin dividers

Drying Rack

To order a drying rack, call the dealer from whom you purchased

your dryer or refer to the "Assistance or Service" section of this

manual. Ask for Part Number 8563738. For more information, see

"Drying Rack."

Stack Kit

Are you planning to stack your DUET SPORT™ washer and

dryer? To do so, you will need to purchase a Stack Kit.

To order, call the dealer from whom you purchased your dryer or

refer to the "Assistance or Service" section of this manual. Ask

for Part Number 8572546.

34.15"

(86.74 cm)

Color

Part Number

White

WHP1000SQ

White

WHP1500SQ

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor

for a garage installation.

Failure to do so can result in death, explosion, or fire.

You will need

A location that allows for proper exhaust installation. A gas

dryer must be exhausted to the outdoors. See "Venting

Requirements."

A grounded electrical outlet located within 2 ft (61 cm) of

either side of the dryer. See "Electrical Requirements."

A sturdy floor to support the total dryer weight of

127 lbs (57.6 kg). The combined weight of a companion

appliance and pedestals should also be considered.

A level floor with a maximum slope of 1" (2.5 cm) under entire

dryer. (If slope is greater than 1" [2.5 cm], install Extended

Dryer Feet Kit, Part Number 279810.) Clothes may not tumble

properly and automatic sensor cycles may not operate

correctly if dryer is not level.

For a garage installation, you will need to place the dryer at

least 18" (46 cm) above the floor. If using a pedestal, you will

need 18" (46 cm) to the bottom of the dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At

lower temperatures, the dryer might not shut off at the end of an

automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will

be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit,

installation of the dryer in garages, closets, mobile homes or

sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the

same closet as a dryer.

Installation clearances

The location must be large enough to allow the dryer door to

open fully.