Whirlpool 883049268804 설치 지침 매뉴얼 - 페이지 15

{카테고리_이름} Whirlpool 883049268804에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 883049268804 44 페이지.

페이지 인쇄

COMPLETE INSTALLATION

CHECKLIST

❑

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

❑

Check that you have all of your tools.

❑

Dispose of/recycle all packaging materials.

❑

Be sure the water faucets are on.

❑

Check for leaks around "Y" connector, faucet, and hoses.

❑

Check dryer's final location. Be sure vent is not crushed

or kinked.

❑

Check that dryer is level. See "Level Dryer".

❑

Remove film on console and any tape remaining on dryer.

❑

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

❑

Read "Dryer Use" in your "Use and Care Guide".

❑

If you live in a hard water area, use of a water softener is

recommended to control the buildup of scale through the

water system in the dryer. Over time, the buildup of lime

scale may clog different parts of the water system, which will

reduce product performance. Excessive scale buildup may

lead to the need for certain part replacement or repair.

Electric Models

❑

Plug into a grounded outlet.

Gas Models

❑

Plug into a grounded outlet.

❑

Check that gas supply is on.

❑

Check for leaks.

❑

Check to be sure that the flexible gas line is not crushed

or kinked.

All Models:

❑

Select a Timed Dry heated cycle, and start dryer. Do not

select Air Only Temperature setting.

If dryer will not start, check the following:

connected.

not tripped.

This dryer automatically runs an installation diagnostic routine

at the start of its first cycle.

NOTE:

You may notice an odor when dryer is first heated. This

odor is common when heating element is first used. The odor will

go away.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with a round and

square-shaped doors.

Tools needed:

Min. 8" long TORX

T25

††

screwdriver

Reverse door swing round-shaped door - single handle

Remove door from dryer

IMPORTANT: If the protective film has not yet been

removed from the dryer, peel the film from the dryer

door before proceeding.

Using a TORX T25 screwdriver, remove the 4 screws securing

the door hinge to the dryer and lift up and out to remove the

door. Place the door on a soft towel or other non-scratch

surface. Reinstall the 4 screws in the holes.

††

® TORX is a registered trademark of Saturn Fasteners, Inc.

#2 Phillips screwdriver