Whirlpool 8TCEM2760KQ0 설치 지침 매뉴얼 - 페이지 16

{카테고리_이름} Whirlpool 8TCEM2760KQ0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8TCEM2760KQ0 36 페이지. Commercial dryer – gas or electric

CHANGING TO A 30- OR

60-MINUTE TIMING CAM

WARNING

Electrical Shock Hazard

Disconnect power before making cam changes.

Failure to follow these instructions can result in death

or electrical shock.

You can install the 30-minute or 60-minute timing cam (shipped

with dryer) as follows:

1. Unplug dryer or disconnect power.

2. Unlock meter case.

3. Turn the timing cam by hand until the V-shaped notch lines up

below the ratchet tooth.

A. Ratchet tooth

B. Timing cam

C. Drive lug

D. V-shaped notch

4. Insert a narrow, flat-blade screwdriver under the timing cam

near the clock shaft. Gently lift cam straight up and off shaft

making sure that the V-shaped notch clears the ratchet tooth.

5. Place new cam (hub side down) over clock shaft. Line up flat

side of shaft with flat side of cam hole. Check that drive lug is

in place.

6. Turn cam until V-shaped notch lines up with ratchet tooth.

7. Press cam down in place on motor shaft. Make sure that

V-shaped notch clears the ratchet tooth.

8. Close and lock the meter case.