Whirlpool AGD4475TQ1 사용자 지침 - 페이지 10

{카테고리_이름} Whirlpool AGD4475TQ1에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AGD4475TQ1 24 페이지.

페이지 인쇄

Is the dryer located in a closet?

■

Closet doors must have ventilation openings at the top and

bottom of the door. Sides and front of dryer require a minimum

of 1" (25 mm) of airspace, and the rear of the dryer requires

5" (127 mm). See the Installation Instructions.

Has an air dry cycle been selected?

■

Select the right cycle for the types of garments being dried.

Is the load too large and heavy to dry quickly?

■

Separate the load to tumble freely.

Cycle time too short

WARNING

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

Is the automatic cycle ending early?

■

The load may not be contacting the sensor strips. Level

the dryer.

Change the dryness level setting on Automatic Cycles.

Increasing or decreasing the dryness level will change

the amount of drying time in a cycle.

Lint on load

Is the lint screen clogged?

■

Lint screen should be cleaned before each load.

Stains on load or drum

Was the dryer fabric softener properly used?

■

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can stain

your garments.

Drum stains are caused by dyes in clothing (usually blue jeans).

■

This will not transfer to other clothing.

Loads are wrinkled

Was the load removed from dryer at the end of

■

the cycle?

Was the dryer overloaded?

■

Dry smaller loads that can tumble freely.

Odors

Have you recently been painting, staining, or

■

varnishing in the area where your dryer is located?

If so, ventilate the area. When the odors or fumes are gone

from the area, rewash, and dry the clothing.

Is the electric dryer being used for the first time?

■

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

Load is too hot

Were laundry items removed from the dryer before the end

■

of the cycle?

Allow the Cool Down cycle to finish before removing laundry

from dryer. All cycles are cooled slowly to reduced wrinkling

and make it easier to handle. Items removed before Cool Down

may feel very warm.

Was a high temperature cycle used, or was a separate

■

temperature control set on high?

Select a lower temperature, and use an automatic drying cycle.

These cycles sense the temperature or the moisture level in the

load and shut off when the load reaches the selected dryness.

This reduces overdrying.

Accessories

Enhance your dryer with these premium accessories.

For more high-quality items or to order, call 1-800-901-2042,

or visit us at www.applianceaccessories.com. In Canada, call

1-800-807-6777 or visit us at www.whirlpoolparts.ca.

Part Number

3404351

Drying rack - fits 29" (737 mm) Super Capacity,

6.5 cu. ft. (0.18 cu. m) - side swing or hamper

door

3406839

Drying rack - fits 29" (737 mm) Super Capacity

Plus, 7.0 cu. ft. (0.20 cu. m) - side swing door

only

Accessory