Whirlpool AWD60A 서비스 매뉴얼 - 페이지 5

{카테고리_이름} Whirlpool AWD60A에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWD60A 22 페이지. Tumble dryer
Whirlpool AWD60A에 대해서도 마찬가지입니다: 운영 매뉴얼 (32 페이지), 운영 매뉴얼 (16 페이지)

페이지 인쇄

WALL MOUNTING INSTRUCTIONS

The dryer can be mounted on a wall in the inverted position only, by following these

instructions.

Invert the dryer so that the control panel is at the bottom (see figure 4) this allows

easier access to the controls.

1. Determine the location of the dryer on the wall and mark the bracket position.

A minimum of 50 mm is needed between the top of the dryer and the ceiling for ease of

installation.

If mounting above a top load washing machine, allow sufficient room to open the lid of the

washer.

TOOLS REQUIRED

For plaster or

timber wall

WALL MOUTING KIT INCLUDES

Description

2. Fix the wall hanging brackets to the wall securely (e.g. into the stud).

If the studs are too far apart, fit a timber slat to the studs then mount the brackets onto

the slat. The distance between each bracket is 553 mm as per diagram.

Warning: Ensure that the screw and nut of the Wall Hanging Brackets are tightened

during installation, if required. Regularly check all the screws and nuts and

tighten, if required. Do not overtighten.

Tumble Dryer

Drill & 3 mm bit

Phillips head screw driver

Plastic spacers

Wall hanging brackets

Hanging hooks

Wood screws, 12 g x 50 mm

Screws for hanging hooks

and plastic spacers

553 mm

Wood screws

Page 3

Model:AWD60A