Whirlpool AWZ 3303 사용 설명서 지침 - 페이지 2
{카테고리_이름} Whirlpool AWZ 3303에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWZ 3303 9 페이지. Air vent electronic
Whirlpool AWZ 3303에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 서비스 매뉴얼 (9 페이지)
페이지 인쇄
BEFORE USING THE DRYER / CONNECTIONS
1. Removing the packaging and check
•
After unpacking, make sure that the dryer is
undamaged. If in doubt, do not use the dryer.
Contact After-Sales Service or your local retailer.
•
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as
they are potentially dangerous.
2. Electrical Connections
•
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer's instructions and current standard
safety regulations.
•
Electrical connection must comply with local
Electricity Board regulations.
•
Voltage information, power consumption and the
required fuse protection is shown on the rating
plate mounted at the rear of the dryer.
The manufacturer cannot accept any liability for
•
personal injury or damage to property resulting
from failure to adhere to these instructions.
•
The dryer must be earthed as prescribed by law.
•
Do not use extension leads or multiple adaptors.
•
Before any maintenance on the dryer disconnect it
from the mains supply.
•
Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales
Service technicians.
•
Mains cable replacement is only to be carried out by
After-Sales Service.
•
After installation access to the mains plug has to be
guaranteed, or the all-pole disconnection has to be
possible with a switch.
3. Installation
• Do not install your dryer where it can be subject
to extreme conditions, such as: poor ventilation,
temperatures around freezing (or above 35°C).
• Remove the protective foil from the control panel.
• Take care not to install the dryer on a deep-pile
carpet.
Stability:
When installing the dryer always carefully level the
dryer adjusting the two feet and check the correct
levelling with a spirit level.
To built in the dryer
• For security reasons do not remove the
worktop.
• Connect the dryer to an external ventilation
system in order to prevent steam from damaging
your furniture during the years.
10
Stacking kit
Your dryer can be stacked on top of your front
loading washing machine. The type of stacking kit is
stated in the Instruction for use of your washing
machine or pls. contact your dealer or our After
Sales Service.
Minimum housing dimensions:
Width:
600 mm
Height:
850 mm
Depth:
560 mm