Whirlpool Cabrio W10150627A 사용 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} Whirlpool Cabrio W10150627A에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Cabrio W10150627A 48 페이지. Fabric care system gas dryer

페이지 인쇄

4. Install the 2 hinges to the front panel of the dryer using

4 screws. Use the non-slotted side to attach the hinge to the

front panel.

5. Install screws in the top hinge holes in the door. Do not

tighten screws. Leave approximately ¼" (5 mm) of screw

exposed.

A. Install these screws first.

6. Hang door by placing screw heads into top slotted holes of

hinges and slide door down. Align bottom screw holes in

hinge and door. Install two bottom screws. Tighten all hinge

screws.

7. Close door to engage door strike.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer's final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is level. See "Level Dryer."

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

6. Plug into a grounded 3 prong outlet. Turn on power.

7. Remove any protective film or tape remaining on the dryer.

NOTE: Glass door models have a protective film on the

window that should be removed.

8. Read "Dryer Use."

9. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. Test dryer operation by selecting a Timed Dry heated cycle

and starting the dryer. For this test, do not select the Air Only

modifier.

If the dryer will not start, check the following:

Dryer is plugged into a grounded 3 prong outlet.

Electrical supply is connected.

Household fuse is intact and tight, or circuit breaker has

not tripped.

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close door. If you do not feel heat, turn off the dryer and

check that the gas supply line shutoff valve is open.

If the gas supply line shutoff valve is closed, open it, then

repeat the 5-minute test as outlined above.

If the gas supply line shutoff valve is open, contact a

qualified technician.