Whirlpool Cabrio W10151493B 사용 및 관리 매뉴얼 - 페이지 8
{카테고리_이름} Whirlpool Cabrio W10151493B에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Cabrio W10151493B 48 페이지. Fabric care system electric dryer
페이지 인쇄
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position. Do not further
tighten strain relief screws at this point.
Style 2: Direct wire strain relief
Unscrew the removable conduit connector and any screws
from a
" (19 mm) UL listed strain relief (UL marking on strain
3
⁄
4
relief). Put the threaded section of the strain relief through the
hole below the terminal block opening. Reaching inside the
terminal block opening, screw the removable conduit
connector onto the strain relief threads.
A. Removable conduit connector
B. Hole below terminal block opening
C. Strain relief threads
Put direct wire cable through the strain relief. The strain relief
should have a tight fit with the dryer cabinet and be in a
horizontal position. Tighten strain relief screw against the
direct wire cable.
4. Now complete installation following instructions for your type
of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
8
Electrical Connection Options
If your home has:
4-wire receptacle
(NEMA type 14-30R)
4-wire direct
3-wire receptacle
(NEMA type 10-30R)
3-wire direct
*If local codes do not permit the connection of a cabinet-ground
A
conductor to the neutral wire, go to "Optional 3-wire
connection" section.
B
4-wire connection: Power supply cord
IMPORTANT: A 4-wire connection is required for mobile homes
and where local codes do not permit the use of 3-wire
C
connections.
A
And you will be
connecting to:
A UL listed,
120/240-volt
minimum,
30-amp, dryer
power supply
cord*
A fused
disconnect or
circuit breaker
box*
5"
(127 mm)
A UL listed,
120/240-volt
minimum,
30-amp, dryer
power supply
cord*
A fused
disconnect or
circuit breaker
box*
3 "
1
⁄
2
(89 mm)
B
D
C
E
A. 4-wire receptacle (NEMA type 14-30R)
B. 4-prong plug
C. Ground prong
D. Neutral prong
E. Spade terminals with upturned ends
⁄
F.
3
" (19 mm) UL listed strain relief
4
G. Ring terminals
Go to Section:
4-wire connection:
Power Supply Cord
4-wire connection:
Direct Wire
3-wire connection:
Power Supply Cord
3-wire connection:
Direct Wire
F
G