Whirlpool cabrio WED6200S 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool cabrio WED6200S에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool cabrio WED6200S 32 페이지. Whirlpool electric dryer dimensions
Whirlpool cabrio WED6200S에 대해서도 마찬가지입니다: 치수 및 설치 (1 페이지), 치수 및 설치 정보 (1 페이지)

페이지 인쇄

Changing Cycles, Modifiers, and Options

You can change Automatic and Timed Cycles, Modifiers, and

Options anytime before pressing Start.

■

Three short tones sound if an unavailable combination is

selected. The last selection will not be accepted.

Changing Cycles after pressing Start

1. Press PAUSE/CANCEL twice.

2. Select the desired cycle and options.

3. Press START. The dryer starts at the beginning of the new

cycle.

NOTE: If you do not press Start within 5 minutes of selecting the

cycle, the dryer automatically shuts off.

Changing Modifiers and Options after pressing Start

You can change an Option or Modifier anytime before the selected

Option or Modifier begins.

1. Press PAUSE/CANCEL once.

2. Select the new Option and/or Modifiers.

3. Press START to continue the cycle.

NOTE: If you happen to press PAUSE/CANCEL twice, the

program clears and your dryer shuts down. Restart the selection

process.

Changing the Preset Dryness Level Settings

If all of your loads on all Auto Dry cycles are consistently not as

dry as you would like, you may change the preset Dryness Level

settings to increase the dryness. This change will affect all of your

Auto Dry cycles.

Your Dryness Level settings can be adjusted to adapt to different

installations, environmental conditions or personal preference.

There are 3 drying settings: 1 (factory preset dryness level),

2 (slightly dryer clothes, approximately 15% more drying time),

and 3 (much dryer clothes, approximately 30% more drying time).

1. The Dryness Level settings cannot be changed while the dryer

is running.

2. Press and hold the DRYNESS button for 5 seconds. The dryer

will beep, and "CF" will be displayed for 1 second followed by

the current drying setting.

3. To select a new drying setting, press the DRYNESS button

again until the desired drying setting is shown.

NOTE: While cycling through the settings, the current setting

will not flash, but the other settings will flash.

4. Press START to save the drying setting.

5. The drying setting you selected will become your new preset

drying setting for all Auto Dry cycles.

Drying Rack Option

Use the Drying Rack to dry items such as sweaters and pillows

without tumbling. The drum turns, but the drying rack does not

move.

If your model does not have a drying rack, you may be able to

purchase one for your model. To find out whether your model

allows drying rack usage and for information on ordering, please

refer to the front page of the manual or contact the dealer from

whom you purchased your dryer.

NOTE: The drying rack must be removed for normal tumbling. Do

not use the automatic cycle with the drying rack.

To use the drying rack

1. Open dryer door.

2. Place drying rack inside dryer drum, positioning the back wire

on the ledge of the inner dryer back panel. Push down on front

edge of drying rack to secure at the front of the dryer.

A. Drying rack front edge

B. Dryer back panel

3. Put the wet items on top of the drying rack. Leave space

between the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying

rack.

4. Close the door.

5. Press the POWER button.

6. Select Timed Dry Cycle and select a temperature (see

following chart). Items containing foam, rubber or plastic must

be dried on a clothesline or by using the Air Only temperature

setting.

7. You must select a time by pressing TIME ADJUST Up or

Down. Reset time as needed to complete drying. Refer to the

following table.

8. Press (and hold) START button (about 1 second).

A. Front edge