Control Panel and Features
Not all features and cycles are available on all models.
1
NOTE: The control panel features a sensitive surface that responds to a light touch of your finger. To ensure your selections are
registered, touch the control panel with your finger tip, not your fingernail. When selecting a setting or option, simply touch its name
until the desired section is illuminated.
POWER BUTTON
1
Touch to turn the washer ON. Touching once while the
washer is on will cancel the current cycle and turn the
washer OFF.
2
WHAT TO WASH/HOW TO WASH
First select a cycle from the "What to Wash" and then
select the "How to Wash" to get the best combination
cycle available for the type of items you are going to
wash. See "Cycle Guide" for cycle details.
START/PAUSE BUTTON
3
Touch and hold START/PAUSE button for 3 seconds to
begin the selected cycle; touch again to pause a cycle.
ADD GARMENT
4
When Add Garment is lit, you may pause the washer, open
the lid, and add items. Touch and hold START to start the
washer again.
TIME/STATUS DISPLAY
The Estimated Time Remaining display shows the time
required for the cycle to complete. Factors such as load
size and water pressure may affect the time shown in
the display. Tightly packed loads, unbalanced loads, or
excessive suds may cause the washer to adjust the cycle
time, as well.
If you have set a delay start to the cycle, the Estimated
Time Remaining display will show the delay time adjusted.
When the cycle is complete, the display will show END until
the lid is opened.
5
OPTIONS
You may add or remove options for each cycle. Not all
options can be used with all cycles, and some are preset
to work with certain cycles.
DELAY START
Touch Delay Start to delay the start of the wash cycle up
to 12 hours "12H". Touch Delay Start until a "0H" appears
in the status display to turn off, or touch POWER.
5
2
4
6
END BEEP
Use this to turn the signal indicating the end of a wash
cycle to low, medium, high, or off.
NOTE: You may also turn off the tones that sound when
a feature, setting, or option is touched. Touch and hold
End Beep for about 3 seconds to turn key activation
sounds on/off.
STEAM CLEAN
The Steam Clean option adds additional soak and wash
time to many cycles to help remove tough stains, as well
as a steam boost for added cleaning power. Steam Clean
uses a heater within the washer to maintain the selected
temperature setting throughout the wash period. Steam
Clean may be selected as an option with other cycles.
ADDITIVES - OXI
Select the Oxi option so that it is added to the load at the
correct time.
UTILITY TOOLS
Clean Washer
Use this every 30 washes to keep the inside of your
washer fresh and clean. This cycle uses a higher water
level. Use with affresh
chlorine bleach to thoroughly clean the inside of your
washer. This cycle should not be interrupted. Also
optimizes load sensing for optimal wash performance.
See "Washer Care."
IMPORTANT: Do not place garments or other items
in the washer during the Clean Washer cycle. Use this
cycle with an empty wash tub.
Rinse & Spin
Combines a rinse and high speed spin for loads
requiring an additional rinse cycle. Also use for loads
that require rinsing only. If you want Drain & Spin
select Rinse & Spin and then deslect Extra Rinse.
EXTRA RINSE
This option can be used to automatically add a second
rinse to most cycles.
PRESOAK
Use this option to add an extra soak period to any cycle
to help loosen tough stains. The washer will fill and then
pause to soak, and then begin the selected cycle.
3
5
7
Washer Cleaner tablet or liquid
®
5
페이지 인쇄