Whirlpool Cabrio,- WED7300X 사용 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} Whirlpool Cabrio,- WED7300X에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Cabrio,- WED7300X 19 페이지. Top-loading high efficiency low-water washer
Whirlpool Cabrio,- WED7300X에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (36 페이지), 사용 및 관리 매뉴얼 (32 페이지), 설치 매뉴얼 (16 페이지), 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (40 페이지), 치수 및 설치 정보 (1 페이지), 치수 매뉴얼 (2 페이지), 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (48 페이지), 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (44 페이지), Gude 사용 및 관리 (44 페이지), 사용 및 관리 매뉴얼 (44 페이지)

페이지 인쇄

NON-USE AND VACATION CARE

Operate your washer only when you are home.

If moving, or not using your washer for a period of time,

follow these steps:

1. Unplug or disconnect power to washer.

2. Turn off water supply to washer, to avoid ooding

due to water pressure surge.

CLEANING YOUR DISPENSER TRAY

You may nd laundry product residue leftover in your

dispenser trays. To remove residue, follow this recommended

cleaning procedure:

1. Pull tray out until you feel resistance.

2. Push 2 tabs downward, and then continue pulling out.

3. Wash in warm, soapy water, using a mild detergent.

4. Rinse with warm water.

5. Air dry, or dry with a towel, then place back into slot.

IMPORTANT: Dispenser trays are not dishwasher safe.

WINTER STORAGE CARE

IMPORTANT:

To avoid damage, install and store washer

where it will not freeze. Because some water may stay in

hoses, freezing can damage washer. If storing or moving

during freezing weather, winterize your washer.

To winterize washer:

1. Shut off both water faucets; disconnect and drain water

inlet hoses.

2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and

run washer on RINSE & SPIN cycle for about

30 seconds to mix antifreeze and remaining water.

3. Unplug washer or disconnect power.

TRANSPORTING YOUR WASHER

1. Shut off both water faucets. Disconnect and drain water

inlet hoses.

2. If washer will be moved during freezing weather, follow

WINTER STORAGE CARE directions before moving.

3. Disconnect drain from drain system.

4. Unplug power cord.

5. Place inlet hoses inside washer basket.

6. Drape power cord and drain hose over the console

and secure with masking tape.

7. Place foam packing ring from original shipping materials

back inside washer. If you do not have packing ring,

place heavy blankets or towels into basket opening.

Close lid and place tape over lid and down front of

washer. Keep lid taped until washer is placed in

new location. Transport Washer in the upright possition.

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage

or moving:

1. Refer to Installation Instructions to locate, level, and

connect washer.

2. Before using again, run washer through the following

recommended procedure:

To use washer again:

1. Flush water pipes and hoses. Reconnect water inlet

hoses. Turn on both water faucets.

2. Plug in washer or reconnect power.

3. Run washer through BULKY/SHEETS cycle to clean

washer and remove antifreeze, if used. Use only HE

High Ef ciency detergent. Use half the manufacturer's

recommended amount for a medium-size load.