Whirlpool Centennial MEDC700 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool Centennial MEDC700에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Centennial MEDC700 16 페이지. 27" wide models - u.s.a. only

페이지 인쇄

3. Install strain relief.

Style 1: Power supply cord strain relief

Remove the screws from a 3/4" (19 mm) UL listed strain relief

■

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole below the terminal block opening

(B) so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

Put power supply cord through the strain relief. Be sure that

■

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.

Style 2: Direct wire strain relief

Unscrew the removable conduit connector (A) and any

■

screws from a 3/4" (19 mm) UL listed strain relief (UL marking

on strain relief). Put the threaded section of the strain

relief (C) through the hole below the terminal block

opening (B). Reaching inside the terminal block opening,

screw the removable conduit connector (A) onto the strain

relief threads.

Put direct wire cable through the strain relief. The strain

■

relief should have a tight fit with the dryer cabinet and be in

a horizontal position. Tighten strain relief screw against the

direct wire cable.

4. Now complete installation following instructions for your type

of electrical connection:

4-wire (recommended)

3-wire (if 4-wire is not available)

4-wire connection: Power supply cord

ImPoRTAnT: A 4-wire connection is required for mobile

homes and where local codes do not permit the use of 3-wire

connections.

1. Remove center, silver-colored terminal block screw (B).

2. Remove neutral ground wire (E) from external ground

conductor screw (A).

A. 4-wire receptacle (NEMA type 14-30R)

B. 4-prong plug

C. Ground prong

D. Neutral prong

E. Spade terminals with upturned ends

F. 3/4" (19 mm) UL listed strain relief

G. Ring terminals