Whirlpool CGM2745FQ 설치 지침 매뉴얼 - 페이지 26

{카테고리_이름} Whirlpool CGM2745FQ에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CGM2745FQ 28 페이지. Commercial dryer gas or electric

CHANGING TO A 30- OR 60-MINUTE TIMING CAM

(on some models)

WARNING

Electrical Shock Hazard

Disconnect power before making cam changes.

Failure to follow these instructions can result in death

or electrical shock.

Coin-slide models: You can install the 30-minute or 60-minute

timing cam (shipped with dryer) as follows:

1. Unplug dryer or disconnect power.

2. Unlock meter case.

3. Turn the timing cam by hand until the V-shaped notch lines

up below the ratchet tooth.

V-Shaped

Ratchet

Notch

Tooth

4. Insert a narrow, at-blade screwdriver under the timing cam

near the clock shaft. Gently lift cam straight up and off shaft,

making sure that the V-shaped notch clears the ratchet tooth.

5. Place new cam (hub side down) over clock shaft. Line up at

side of shaft with at side of cam hole. Check that drive lug

is in place.

Drive Lug

6. Turn cam until V-shaped notch lines up with ratchet tooth.

7. Press cam down in place on clock shaft. Make sure that

V-shaped notch clears the ratchet tooth.

8. Close and lock the meter case.

9. Plug in dryer or reconnect power.