Whirlpool CGM2793BQ 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} Whirlpool CGM2793BQ에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CGM2793BQ 48 페이지. Commercial dryer gas or electric
Whirlpool CGM2793BQ에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (48 페이지)

페이지 인쇄

ELECTRIC DRYER INSTALLATION REQUIREMENTS

Direct Wire

Electrical Requirements – Canada only

It is your responsibility:

To contact a qualified electrical installer.

■

To be sure that the electrical connection is adequate

■

and in conformance with the Canadian Electrical Code,

C22.1 – latest edition and all local codes. A copy of the

above codes standard may be obtained from: Canadian

Standards Association, 178 Rexdale Blvd., Toronto, ON

M9W 1R3 CANADA.

To supply the required 4 wire, single phase, 120/240 volt,

■

60 Hz., AC only electrical supply on a separate 30-amp

circuit, fused on both sides of the line. A time-delay fuse

or circuit breaker is recommended. Connect to an individual

branch circuit.

This dryer is equipped with a CSA International

■

Certified Power Cord intended to be plugged

into a standard 14-30R wall receptacle. The

cord is 5 ft (1.52 m) in length. Be sure wall

receptacle is within reach of dryer's final

location.

If connecting by direct wire:

Power supply cable must match power supply (4-wire or 3-wire)

and be:

Flexible armored cable or nonmetallic sheathed copper

■

cable (with ground wire), covered with flexible metallic

conduit. All current-carrying wires must be insulated.

10-gauge solid copper wire (do not use aluminum).

■

At least 5 ft. (1.52 m) long.

■

Do not use an extension cord.

■

If you are using a replacement power supply cord,

it is recommended that you use Power Supply Cord

Replacement Part Number 9831317. For further information,

please reference the service numbers located in the

"Assistance or Service" section.

For a grounded, cord-connected dryer:

This dryer must be grounded. In the event of malfunction or

breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current.

This dryer is equipped with a cord having an equipment-

grounding conductor and a grounding plug. The plug must

be plugged into an appropriate outlet that is properly

installed and grounded in accordance with all local codes

and ordinances.

WARNING:

grounding conductor can result in a risk of electric shock.

Check with a quali ed electrician or service representative

or personnel if you are in doubt as to whether the dryer is

properly grounded. Do not modify the plug provided with

the dryer: if it will not t the outlet, have a proper outlet

installed by a quali ed electrician.

4-Wire

Receptacle

(14-30R)

GROUNDING INSTRUCTIONS

Improper connection of the equipment-

SAVE THESE INSTRUCTIONS