Whirlpool CGW9100VQ0 설치 매뉴얼 - 페이지 22

{카테고리_이름} Whirlpool CGW9100VQ0에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CGW9100VQ0 40 페이지. Commercial dryer- gas or electric

페이지 인쇄

1. Use a small flat-blade screwdriver to remove plug strip from

the dryer door opening. Slide the head of the screwdriver

under the strip, being sure not to scratch the dryer surface.

Lift up.

2. Remove the strike using a #2 Phillips screw driver.

3. Install strike on the opposite side.

A. Plug strip (cannot be

seen from this angle)

B. Door catch

Reattach door to dryer front panel with the 4 screws.

A. Dryer front panel

B. Door assembly

f--..

2. Check for fingerprints on the inside of the glass.

Clean glass if necessary.

3. Close door and check that it latches securely.

ELECTRONIC CONTROL SETUP

See Tech Sheet for information on setup.

MAINTENANCE INSTRUCTIONS

Maintenance

instructions:

m Clean lint screen after each cycle.

m Removing accumulated

lint:

* From inside the dryer cabinet:

Lint should be removed every 2 years or more often,

depending on dryer usage. Cleaning should be done

by a qualified person.

From the exhaust vent:

Lint should be removed every 2 years, or more often,

depending on dryer usage.

m Keep area around dryer clear and free from combustible

materials, gasoline and other flammable vapors and liquids.

m Keep dryer area clear and free from items that would obstruct

the flow of combustion and ventilation air.

If dryer does not operate,

check the following:

[] Electric supply is connected.

[] Circuit breaker is not tripped or house fuse is not blown.

[] Door is closed.

[] Controls are set in a running or "ON" position.

[] START button has been pushed firmly.

[] For gas dryers, check that gas supply shutoff valves are set

in open position.

If you need assistance:

The Commercial Laundry Support Center will answer any

questions about operating or maintaining your dryer not covered

in the Installation Instructions. The Commercial Laundry Support

Center is open 24 hours a day, 7 days a week. Just dial

1-800 NO BELTS (1-800-662-3587)

-- the call is toll free.

When you call, you will need the dryer model number and serial

number. Both numbers can be found on the serial-rating plate

located in the dryer door well.