Whirlpool Commercial Dryer 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} Whirlpool Commercial Dryer에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Commercial Dryer 28 페이지. Commercial dryer gas (120-volt, 60-hz) or electric (120/240-volt, 60-hz)

페이지 인쇄

ELECTRIC DRYER ELECTRICAL REQUIREMENTS

Electric Dryer Power Supply Cord

If using a power supply cord:

Use a UL listed power supply cord kit marked for use with

clothes dryers. The kit should contain:

A UL listed 30-amp power supply cord, rated 120/240

■

volt minimum. The cord should be type SRD or SRDT and

be at least 4 ft. (1.22 m) long. The wires that connect to

the dryer must end in ring terminals or "U" shaped spade

terminals with upturned ends.

A UL listed strain relief.

■

If your outlet looks like this:

Then choose a 4-wire power supply cord with ring

or spade terminals and UL listed strain relief. The

4-wire power supply cord, at least 4 ft. (1.22 m)

long, must have four 10-gauge copper wires and

match a 4-wire receptacle of NEMA Type 14-30R.

The ground wire (ground conductor) may be

4-wire

either green or bare. The neutral conductor must

receptacle

be identified by a white cover.

(14-30R)

If your outlet looks like this:

Then choose a 3-wire power supply cord with

ring or spade terminals and UL listed strain relief.

The 3-wire power supply cord, at least 4 ft. (1.22

m) long, must have three 10-gauge copper wires

and match a 3-wire receptacle of NEMA Type

10-30R.

3-wire

receptacle

(10-30R)

Direct Wire

If connecting by direct wire:

Power supply cable must match power supply (4-wire or

3-wire) and be:

Flexible armored cable or nonmetallic sheathed copper

■

cable (with ground wire), covered with flexible metallic

conduit. All current-carrying wires must be insulated.

10-gauge solid copper wire (do not use aluminum).

■

At least 5 ft. (1.52 m) long.

■