Whirlpool CSP2760TQ3 설치 지침 매뉴얼 - 페이지 16

{카테고리_이름} Whirlpool CSP2760TQ3에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CSP2760TQ3 36 페이지. Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)

페이지 인쇄

(iii _ i:i ¸, _::i_

i_i :i_ _i:::_

_iii_

ii__iiii _i!i_

_ :i_ i i:_

1. Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure the vent is

clean. The dryer vent must fit over the dryer exhaust outlet

and inside the exhaust hood. Make sure the vent is secured

to exhaust hood with a 4" (102 mm) clamp.

2. Using two or more people, move dryer to desired installation

location. Do not crush or kink vent. Make sure dryer is level.

3. Check dryer operation.

Select a full heat cycle, let the dryer run for at least five

minutes. Dryer wilt stop when time is used up.

NOTE: Dryer door must be closed for dryer to operate. When

door is opened, dryer stops, but time continues to count

down. To restart dryer, close door and reselect cycle.

4. Now start the dryer and allow it to complete a full heat cycle

to make sure it is working properly.

1. With dryer in final position, place level on top of the dryer, first

side to side; then front to back. If the dryer is not level, adjust

the legs of the dryer up or down until the dryer is level.

2. Plug in dryer or reconnect power.

CHANGING TOA 30- OR60-MINUTETIMINGCAM

Electrical Shock Hazard

Disconnect power before making cam changes.

Failure to follow

these instructions can result in death

or electrical

shock.

Insert a narrow, flat-blade screwdriver under the timing cam

near the clock shaft. Gently lift cam straight up and off shaft

making sure that the V-shaped notch clears the ratchet tooth.

You can install the 30-minute or 60-minute timing cam (shipped

with dryer) as follows:

1. Unplug dryer or disconnect power.

2. Unlock control panel. Lift up and rotate out from cabinet.

Control panel will still be attached to cabinet.

3. Use a Phillips screwdriver to loosen (but not remove) timer

mounting bracket screw. Lift up to remove timer assembly

and bracket from cabinet.

4. Turn the timing cam by hand until the V-shaped notch lines up

below the ratchet tooth.

6. Place new cam (hub side down) over clock shaft. Line up flat

side of shaft with flat side of cam hole. Check that drive lug is

in place.

7. Turn cam until V-shaped notch lines up with ratchet tooth.

8. Press cam down in place on clock shaft. Make sure that

V-shaped notch clears the ratchet tooth.

9. Reattach the timer bracket assembly; then tighten the screws.

10. Repeat steps for the other timer.

11. Close and lock the control panel.

12. Plug in dryer or reconnect power.

A. Ratchet tooth

B. Timing cam

C. V-shaped notch