Whirlpool CSP2761TQ3 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} Whirlpool CSP2761TQ3에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CSP2761TQ3 36 페이지. Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)

페이지 인쇄

INSTALLATION INSTRUCTIONS - GASDRYER

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

1. Remove red cap from gas pipe.

2. Connect gas supply to dryer. Use pipe-joint compound

resistant to the action of LR gas for gas connections. If

flexible metal tubing is used, be certain there are no kinks.

If necessary for service, open the toe panel. Use a putty knife

to press on the toe panel locks located at the upper corners

of the toe panel. Pull downward on the toe panel to open.

Toe panel is hinged at the bottom.

3. Open the shutoff valve in the gas supply line.

4. Test all connections by brushing on an approved noncorrosive

leak-detection solution. Bubbles will show a leak. Correct any

leaks found.

1. Using a 4" (102 mm) clamp, connect vent to exhaust outlet

on rear of dryer. If connecting to existing vent, make sure the

vent is clean. The dryer vent must fit over the dryer exhaust

outlet and inside the exhaust hood. Make sure the vent is

secured to exhaust hood with a 4" (102 mm) clamp.

2. Using two or more people, move dryer to desired installation

location. Do not crush or kink vent. Make sure dryer is level.

3. Check that there are no kinks in the flexible gas line.

With dryer in final position, place level on top of the dryer, first

side to side; then front to back. If the dryer is not level, adjust

the legs of the dryer up or down until the dryer is level.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground

prong.

Do not use an adapter,

Do not use an extension

cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

2. Plug into a grounded 3 prong outlet.

3. Check dryer operation.

Select a full heat cycle, let the dryer run for at least five

minutes. Dryer will stop when time is used up.

NOTE: Dryer door must be closed for dryer to operate. When

door is opened, dryer stops, but time continues to count

down. To restart dryer, close door and resetect cycle.

4. If the burner does not ignite and you can feel no heat inside

the dryer, shut off dryer for five minutes. Check that all supply

valve controls are in "ON" position and that the electrical cord

is plugged in. Repeat five-minute test.

INSTALLATION INSTRUCTIONS-ELECTRICDRYER

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

Power

Supply

Cord Method

- U.S. Only

[]

This dryer is manufactured ready to install with a 3-wire

electrical supply connection. The neutral ground conductor is

permanently connected to the neutral conductor (white wire)

within the dryer. If the dryer is installed with a 4-wire electrical

supply connection, the neutral ground conductor must be

removed from the external ground connector (green screw),

and secured under the neutral terminal (center or white wire)

of the terminal block. When the neutral ground conductor is

secured under the neutral terminal (center or white wire) of

the terminal block, the dryer cabinet is isolated from the

neutral conductor.