Whirlpool Drying Cabinet 사용 및 관리 매뉴얼 - 페이지 5

{카테고리_이름} Whirlpool Drying Cabinet에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Drying Cabinet 16 페이지. Whirlpool drying cabinet use & care guide

페이지 인쇄

DRYING CABINET USE

Starting Your Drying Cabinet

The drying cabinet is used for flat or hang drying. The following is

a guide to starting your drying cabinet. Please refer to specific

sections of this manual for more detailed information.

1. Place laundry in the drying cabinet and close the door. See

"Loading."

2. Select the correct temperature setting and drying time for

your load. See "Cycles."

3. Turn the TIME control knob to set a drying time up to 4 hours.

4. Press START.

Stopping Your Drying Cabinet

To stop your drying cabinet at any time:

Open the door and turn the TIME control knob to "0."

Pausing or Restarting

To pause your drying cabinet at any time:

Open the door.

To restart your drying cabinet:

Close the door and press START.

NOTE: The drying cycle will continue from the point when the

cycle was interrupted. To cancel a cycle, turn the TIME control

knob back to "0."

The drying cabinet contains 3 racks with built-in hangers. The

racks can be pulled out on rails to allow for easier loading and

hanging convenience. Slide the racks toward you to load, and

slide back after loading.

Loading suggestions

Load the drying cabinet by the amount of space items take

up, not by their weight.

For optimal performance, do not place flat-dry items on the

top rack.

Longer items should be hung next to the walls and shorter

items in the middle. This will increase drying efficiency.

Fold the lower 2 racks up flat against the back of the drying

cabinet to allow for longer items to be dried.

Hang gloves, hats, scarves or other small flat items on the

racks located on the door.

Slide the hanger attachments on the top rack forward to load

clothing on the hangers. Slide to the back of the rack when

not in use.

Do not overload the drying cabinet. This causes wrinkling and

uneven drying.

To prevent dye transfer, allow extra spacing between

noncolorfast items.

Standard loads consist of:

2 flat-dry items

up to 8 long hang-dry garments

any combination of the two categories of items listed above

items placed on the floor, such as boots

flat items on the door racks, such as gloves and scarves

Airflow inside drying cabinet

Cycle and Drying Tips

Cycle tips

Set controls for the most delicate fabric in the load.

If you wish to extend the length of drying time, use the TIME

control knob to set more drying time.

If you wish to change the cycle setting, set the CYCLE control

knob to a different setting.

Drying tips

Follow the care label directions when they are available.

Do not place fabric softener sheets in the drying cabinet.

Remove items from the drying cabinet as soon as they are

dry. Doing this will help decrease the dry time for any

remaining damp garments.