Whirlpool Duet GEW9250PL 사용 및 관리 매뉴얼 - 페이지 22

{카테고리_이름} Whirlpool Duet GEW9250PL에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Duet GEW9250PL 24 페이지. Electronic electric dryer

페이지 인쇄

Moving care

Emectrica_ Shock Hazard

Disconnect

power before servicing.

Replace aimparts and panemsbefore operating.

Failure to do so can result }n death or emectr}cal shock.

1. Unplug dryer or disconnect

power. Disconnect

wiring if dryer

is direct wired.

2. Make sure leveling legs are secure in dryer base.

3. Use masking tape to secure dryer door.

The dryer light automatically turns on inside the dryer drum when

you open the door.

To change the drum light

1. Unplug dryer or disconnect

power.

2. Open the dryer door. Locate the light bulb cover on the back

wall of the dryer. Remove the screw located in the lower right

corner of the cover. Remove the cover.

3. Turn bulb counterclockwise.

Replace the bulb with a lO-watt

appliance bulb only. Replace the cover and secure with the

screw.

4. Plug in dryer or reconnect power.

TROUBLESHOOTING

First try the solutions suggested

here and possibly avoid the cost

Dryer displaying

code message

•

"PF" (power failure), check the following:

Was the drying cycle interrupted

by a power failure?

Press (and hold) HOLD TO START button to restart the dryer.

•

"E" Variable (El, E2, E3) service

codes:

Call for service.

of a service call...

Is the dryer located in a room with temperature

below

45°F (7°C)?

Proper operation of dryer cycles requires temperatures

above

45°F (7°C).

•

Was a cold rinse water used? Was the load very wet?

Expect longer drying times with items rinsed in cold water

and with items that hold moisture (cottons).

•

Is the load too large and heavy to dry quickly?

Separate the load to tumble freely.

Dryer will not run

•

Check the following:

Is the power cord plugged in?

Has a fuse blown, or has a circuit breaker tripped?

Was a regular fuse used? Use a time-delay fuse.

Is the dryer door firmly closed? If not, the time display will

blink.

Was HOLD TO START firmly pressed and held for at least

1 second?

Is a cycle selected?

Unusual

sounds

•

Has the dryer had a period of non-use?

If the dryer hasn't been used for a while, there may be a

thumping sound during the first few minutes of operation.

Clothes

are not drying satisfactorily

•

Checkthe

following:

Is the lint screen clogged with lint?

Is the exhaust vent or outside exhaust hood clogged with lint,

restricting air movement? Run the dryer for 5-10 minutes.

Hold your hand under the outside exhaust hood to check air

movement.

If you do not feel air movement, clean exhaust

system of lint or replace exhaust vent with heavy metal or

flexible metal vent. See "Installation Instructions."

Is the exhaust vent crushed or kinked? Replace with a heavy

metal or flexible metal vent. See "Installation

Instructions."

Has a fuse blown, or has a circuit breaker tripped? Electric

dryers use 2 household fuses or breakers. The drum may be

turning, but you may not have heat.

Has an air cycle been selected? Select the right cycle for the

types of garments being dried. See "Cycles."

Is the automatic cycle ending early? The load may not be

contacting

the electronic sensor strips. Level the dryer.

Are fabric softener sheets blocking the grille? Use only one

fabric softener sheet and only use it once.