Whirlpool Duet GGW9200LW 사용 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} Whirlpool Duet GGW9200LW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Duet GGW9200LW 48 페이지. Electronic gas dryer

Remove

the door

1. Open the dryer door. Remove the 5 screws that hold the door

hinge on the front panel of the dryer. Loosen, but do not

remove, the screw with the top keyhole opening LAST

(second from the top).

Lift and pull forward on the door so that the screwhead clears

the keyhole. Remove the door.

Lay the dryer door on a flat, protected surface with the inside

door assembly facing up. Remove the 2 screws holding the

handle to the door. Pull handle straight out and set aside. A

new handle is provided.

Reverse the hinge and hinge bracket

1. Place the inner door, screwhead side up, on the work surface.

2. Remove the 4 screws that hold the hinge to the door.

3. Remove the 2 screws that hold the handle bracket to the

door.

NOTE: Keep this handle in case you decide to return the door

to its original position.

Remove the 6 screws to release the outer door assembly

from the inner door assembly (see illustration). It is important

that you remove ONLY the 6 indicated screws.

Lift the inner door assembly off of the outer door assembly.

Set the outer door assembly aside.

4. Move hinge to the other side and reattach.

5. Move handle bracket to the other side and reattach.

6. Set the inner door assembly aside.

Reinstalling

the door

1. Check for fingerprints

on the glass. Clean if necessary.

2. Place the inner door assembly into the outer door assembly.

Align the hinge in the opening on the side. To fit correctly, the

inside door assembly edge is completely

inside the outside

door assembly edge.

3. Reassemble the inner and outer door assemblies with the 6

screws.