Whirlpool Duet Steam WED95HEX 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool Duet Steam WED95HEX에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Duet Steam WED95HEX 16 페이지. Electronic dryer
Whirlpool Duet Steam WED95HEX에 대해서도 마찬가지입니다: 치수 매뉴얼 (2 페이지), 사양 (1 페이지), 사용 및 관리 매뉴얼 (40 페이지)

페이지 인쇄
Whirlpool Duet Steam WED95HEX 설치 지침 매뉴얼
2. Remove the hold-down screw and terminal block cover.
C
B
A
A. Neutral ground wire
B. External ground conductor screw
C. Center, silver-colored terminal block screw
D. Terminal block cover and hold-down screw
3. Install strain relief.
Style 1: Power supply cord strain relief
■
Remove the screws from a
(UL marking on strain relief). Put the tabs of the two clamp
sections into the hole below the terminal block opening so
that one tab is pointing up and the other is pointing down,
and hold in place. Tighten strain relief screws enough to hold
the two clamp sections together.
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
■
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position.
Do not further tighten strain relief screws at this point.
D
3
/
" (19 mm) UL listed strain relief
4
A
B
C
D
Style 2: Direct wire strain relief
WARNING
Fire Hazard
Use 10 gauge solid copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
■
Unscrew the removable conduit connector and any screws
from a
/
" (19 mm) UL listed strain relief (UL marking on
3
4
strain relief). Put the threaded section of the strain relief
through the hole below the terminal block opening.
Reaching inside the terminal block opening, screw the
removable conduit connector onto the strain relief threads.
A. Removable conduit connector
B. Hole below terminal block opening
C. Strain relief threads
A
B
C
7