Whirlpool Electric and Gas Dryers 사용 및 관리 매뉴얼 - 페이지 21
{카테고리_이름} Whirlpool Electric and Gas Dryers에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Electric and Gas Dryers 33 페이지. Commercial dryers
Whirlpool Electric and Gas Dryers에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (28 페이지), 사용 및 관리 매뉴얼 (21 페이지), 설치 지침 매뉴얼 (8 페이지), 사용 및 관리 매뉴얼 (31 페이지)
페이지 인쇄
Removing
accumulated
lint
Lint can gather inside the dryer and be a fuel
for fire. It is recommended the lint be removed
every 2 to 3 years, or more often, depending
on dryer usage. Cleaning should be done by a
qualified person. If you have any questions,
please call our Consumer Assistance Center at
l-800-253- 130 1.
Electrlcal Shock and
Personal InJury Hazard
l
Unplug the power supply cord or turn off
the electrical power before removing
dryer panels.
l
Make sure the dryer is cool.
l
Dryer parts can have sharp edges. Use
care when handling.
l
When replacing front panel after lint
removal, the wire clips holding the door
I
switch wires must be anchored to top of
front and side panels. Wires MUST NOT
touch rotating drum. (See page 22,
step 7.)
Failure to do so could result in electrical
1 shock or personal injury.
For all electrk
dryers, or gas dryers which
have a lower front access panel
NOTE: See page 22 if your dryer is gas and
has a full front panel.
1. Unplug the power supply cord or turn off the
electrical power.
2. Remove back panel (electric) or lower front
access panel (gas). See the Installation
Instructions.
3. Remove lint from shaded area in illustration
with a soft brush or vacuum cleaner. Avoid
damaging wires, thermostats (electric),
funnel (gas) or ignitor (gas).
4. Replace panel; reconnect and level dryer
again, if necessary.
Thermostats
Heat element
Electric dryer with back panel removed
I
Gas dryer with lo-o-;J;t
access panel
21