Whirlpool Gold GGQ9800PB0 사용자 지침 - 페이지 6

{카테고리_이름} Whirlpool Gold GGQ9800PB0에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Gold GGQ9800PB0 16 페이지. Whirlpool dryer user instruction
Whirlpool Gold GGQ9800PB0에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (20 페이지)

페이지 인쇄

As Needed Cleaning

1. Roll lint off the screen with your fingers.

2. Wet both sides of lint screen with hot water.

3. Wet a nylon brush with hot water and liquid detergent. Scrub

lint screen with the brush to remove residue buildup.

4. Rinse screen with hot water.

5. Thoroughly dry lint screen with a clean towel. Replace screen

in dryer.

Cleaning the Dryer Interior

1. Apply a nonflammable household cleaner to the stained area

of the drum and rub with a soft cloth until stain is removed.

2. Wipe drum thoroughly with a damp cloth.

3. Tumble a load of clean cloths or towels to dry the drum.

NOTE: Garments which contain unstable dyes, such as denim

blue jeans or brightly colored cotton items, may discolor the dryer

interior. These stains are not harmful to your dryer and will not

stain future loads of clothes. Dry unstable dye items inside-out to

prevent dye transfer.

First try the solutions suggested here and possibly avoid the cost of a service call...

Dryer Operation

Message Codes - Electronic models only

For error message "PF" (power failure), check the

following:

Is the dryer connected to the power supply?

Was the dryer connected to a power supply during installation

or a power failure?

Press START to resume operation or press PAUSE/CANCEL

to cancel the cycle.

Was the drying cycle interrupted by a power failure?

Press START to resume operation or press PAUSE/CANCEL

to cancel the cycle.

For error message "E1" or "E2" (service codes):

Service is required. Call for service.

Dryer will not run

Check the following:

Is the power cord plugged in?

Has a fuse blown, or has a circuit breaker tripped? There

may be 2 fuses or circuit breakers for the dryer. Check to

make sure both fuses are intact and tight, or that both circuit

breakers have not tripped.

Was a regular fuse used? Use a time-delay fuse.

Is the dryer door firmly closed?

Was the START pad firmly pressed?

Is a cycle selected?

No heat

Has a fuse blown, or has a circuit breaker tripped? Electric

dryers use 2 household fuses or breakers. The drum may be

turning, but you may not have heat.

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending

on dryer usage. Cleaning should be done by a qualified person.

From Inside the Exhaust Vent

Lint should be removed every 2 years, or more often, depending

on dryer usage.

1. Unplug dryer or disconnect power.

2. Open the dryer door. Locate the light bulb cover on the back

3. Turn bulb counterclockwise. Replace the bulb with a 10-watt

4. Plug in dryer or reconnect power.

TROUBLESHOOTING

Unusual sounds

Clothes are not drying satisfactorily

Removing Accumulated Lint

Changing the Drum Light

wall of the dryer. Remove the screw located in the lower right-

hand corner of the cover. Remove the cover.

appliance bulb only. Replace the cover and secure with the

screw.

Has an air dry cycle been selected? Select the right cycle

for the types of garments being dried.

For gas dryers, is the valve open on the supply line?

Has the dryer had a period of non-use? If the dryer hasn't

been used for a while, there may be a thumping sound during

the first few minutes of operation.

Is it a gas dryer? The gas valve clicking is a normal operating

sound.

Dryer Results

Check the following:

Is the lint screen clogged with lint?

Is the exhaust vent or outside exhaust hood clogged with lint,

restricting air movement? Run the dryer for 5-10 minutes.

Hold your hand under the outside exhaust hood to check air

movement. If you do not feel air movement, clean exhaust

system of lint or replace exhaust vent with heavy metal or

flexible metal vent. See your Installation Instructions.

Is the exhaust vent crushed or kinked? Replace with heavy

metal or flexible metal vent. See your Installation Instructions.

Are fabric softener sheets blocking the grille? Use only one

fabric softener sheet, and use it only once.

Is the dryer located in a room with temperature below

45ºF (7ºC)? Proper operation of dryer cycles requires

temperatures above 45ºF (7ºC).

Was a cold rinse water used? Was the load very wet?

Expect longer drying times with items rinsed in cold water and

with items that hold moisture (cottons).

Is the load too large and heavy to dry quickly? Separate the

load to tumble freely.