Whirlpool WGD7500GC 사용 및 관리 매뉴얼 - 페이지 11
{카테고리_이름} Whirlpool WGD7500GC에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD7500GC 32 페이지. Electronic dryer
Whirlpool WGD7500GC에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (40 페이지), 사용 및 관리 매뉴얼 (48 페이지)
페이지 인쇄
NON-USE, STORAGE, AND MOVING CARE
Non-use or storage care
Operate your dryer only when you are at home. If you will
be on vacation or not using your dryer for an extended period
of time, you should:
1. Unplug dryer or disconnect power.
2. Clean lint screen. See the "Cleaning the Lint
Screen" section.
Moving care
For power supply cord-connected dryers:
1. Unplug the power supply cord.
2. Gas models only: Close shut-off valve in gas supply line.
3. Gas models only: Disconnect gas supply line pipe and
remove fittings attached to dryer pipe.
4. Gas models only: Cap the open fuel supply line.
5. Make sure leveling legs are secure in dryer base.
6. Use tape to secure dryer door.
For direct-wired dryers:
1. Disconnect power.
2. Disconnect wiring from dryer and secure wire ends.
3. Make sure leveling legs are secure in dryer base.
4. Use tape to secure dryer door.
Reinstalling the dryer
Follow the Installation Instructions to locate, level,
and connect the dryer.
CHANGING THE DRUM LIGHT
1. Unplug dryer or disconnect power.
2. Open the dryer door. Locate the light bulb cover on the
back wall of the dryer. Using a 1/4" (6 mm) nut driver or
socket wrench, remove the screw located in the lower
right-hand corner of the cover. Remove the cover.
3. Turn bulb counterclockwise. Replace the bulb with
a 10-watt appliance bulb only. Replace the cover
and secure with the screw.
4. Plug into a grounded outlet or reconnect power.
11