Whirlpool WGD7600XW0 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} Whirlpool WGD7600XW0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD7600XW0 32 페이지. 27" gas dryer
Whirlpool WGD7600XW0에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (32 페이지)

페이지 인쇄

1. Troubleshooting

CONNECT INLET HOSE

(STEAM MODELS)

The dryer must be connected to the cold water faucet using the new

inlet hoses. Do not use old hoses.

1. Turn cold water faucet off and remove washer inlet hose.

2. Remove old rubber washer from inlet hose and replace with new

rubber washer provided. If space permits, attach the brass female

end of the "Y" connector to the cold water faucet.

NOTE: If "Y" connector can be attached directly to cold water

faucet, go to Step 6. If "Y" connector cannot be attached

directly to the cold water faucet, the short hose must be used.

Continue with Step 3.

3. Attach short hose to cold water faucet. Screw on coupling

by hand until it is seated on faucet.

4. Using pliers, tighten the couplings with an additional two-thirds

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

5. Attach "Y" connector to brass male end of small hose. Screw

on coupling by hand until it is seated on connector.

6. One end of the long hose has a wire mesh strainer inside

the coupling. Attach this end to the "Y" connector.

7. Attach washer cold inlet hose to other end of "Y" connector.

Screw on coupling by hand until it is seated on connector.

A. Inlet to cold water

8. Using pliers, tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

9. Attach other end of long hose to fill valve at bottom of dryer back

panel. Screw on coupling by hand until it is seated on fill valve

connector.

10. Using pliers, tighten the coupling an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

11. Check that the water faucets are on.

12. Check for leaks around "Y" connector, faucet, and hoses.

Check the levelness of the dryer by first placing a level on the top

of the dryer near the console.

Then, by placing a level in the crease on the side of the dryer

between the top of the dryer and the dryer cabinet, check

the levelness from front to back.

If the dryer is not level, prop up the dryer using a wood block. Use a

wrench to adjust the legs up or down and check again for levelness.

11"

(368 mm)

LEVEL DRYER

(95 mm)