Whirlpool WGD8500DW 설치 지침 매뉴얼 - 페이지 22

{카테고리_이름} Whirlpool WGD8500DW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD8500DW 44 페이지. Gas and electric
Whirlpool WGD8500DW에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (44 페이지)

페이지 인쇄

REVERSE DOOR SWING

Tools needed:

Flat-blade screwdriver

Min. 8" long TORX T25

® †

screwdriver

You can change your door swing from a right-side opening

to a left-side opening, if desired.

1. Place a towel or soft cloth on top of dryer or work space

to avoid damaging the surface.

Remove door from dryer cabinet

1. Open the dryer door.

2. Using a TORX T25

screwdriver, remove the bottom screw

(B) from each of the two hinges that attach dryer door to front

panel of dryer.

3. Using a TORX T25

screwdriver, loosen the top screw (A) from

each of the two hinges in Step 2.

4. Remove the dryer door and the hinges by lifting upward and

out to lift the door off the cabinet. Lay the door on a flat,

covered surface, with the inside of the door facing up. Remove

remaining two loose screws from dryer front panel. Set the

hinge screws off to the side for reinstalling the door.

Plastic putty knife

#2 Phillips screwdriver

5. Remove the 2 plastic plugs (A) located outside the dryer

door opening.

6. Install 2 plastic plugs (A) into screw holes where the hinges

were removed in Step 4.

Reverse the strike

1. Remove the door strike (A) from the dryer door opening.

2. Remove the cosmetic screw (B) opposite the door strike (A).

A. Door strike

B. Cosmetic screw

3. Reinstall the door strike and cosmetic screw on the opposite

side of dryer door opening from where they were removed.

NOTE: Door strike and plugs must be on the same side

of the dryer door opening.

® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.

†