Whirlpool WGD8900BW 사용 및 관리 매뉴얼 - 페이지 15

{카테고리_이름} Whirlpool WGD8900BW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD8900BW 38 페이지. Cabrio electronic dryer
Whirlpool WGD8900BW에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)

페이지 인쇄

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -

If you experience

Dryer Results (cont.)

Load too hot

Dryer Displaying Code Message

"PF" (power failure)

"L2" Diagnostic Code

(low or no line voltage

condition)

"F# E#" (F1 E1, F3 E1,

etc.) variable service

codes.

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.

Possible Causes

Load removed before cool down

portion of cycle complete.

Using Timed Dry Cycle with a high

temperature setting.

The drying cycle has been interrupted

by a power failure.

There may be a problem with your

home power supply keeping the

dryer's heater from turning on.

The dryer is in need of service.

Allow the dryer to complete the cool down portion of the cycle

before removing the load.

Select an Automatic cycle with a lower heat setting to avoid

overdrying the load.

Press START/PAUSE twice to resume the cycle, or press

POWER to select a new cycle.

The dryer will continue to run when this diagnostic code

is present. Press any key to clear the code from the display

and return to the estimated time remaining.

Try the following:

Check to see if a household fuse has blown or circuit

breaker has tripped. Electric dryers use two household fuses

or breakers. Replace the fuse or reset the circuit breaker.

Confirm the power cord is properly installed. Refer to

"Installation Instructions" for details.

Select a Timed Dry heated cycle, and restart the dryer.

If the message persists, consult a qualified electrician.

If a code beginning with an "F" appears in the display.

Alternating between F# and E#, the dryer control has

detected a problem that requires service. Call for service.

Solution