Whirlpool WGD9051YW 사용자 설명서 - 페이지 14

{카테고리_이름} Whirlpool WGD9051YW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9051YW 32 페이지. Electronic dryer
Whirlpool WGD9051YW에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (20 페이지)

페이지 인쇄

1. Troubleshooting

Attach short hose and "Y" connector

Fig. A

If space permits, attach the brass female end of the "Y"

connector to the cold water faucet. See figure A.

If "Y" connector cannot be attached directly to the cold water

faucet, the short hose must be used. See figure B. Attach

short hose to cold water faucet. Screw on coupling by hand

until it is seated on faucet. Then attach "Y" connector to

brass male end of the short hose. Screw on coupling by hand

until it is seated on connector.

Tighten couplings

Using pliers, tighten the couplings with additional

two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can

result.

Attach long hose to "Y"

connector and tighten couplings

Fig. B

One end of the long hose has a wire mesh strainer inside the

coupling. Attach this end to the "Y" connector. Attach washer

cold inlet hose to other side of "Y" connector. Screw on

coupling by hand until it is seated on connector. Using pliers,

tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can

result.

Attach long hose to dryer fill valve

and tighten coupling

Attach other end of long hose to

fill valve at bottom of dryer back

panel. Screw on coupling by hand

until it is seated on fill valve connector. Using pliers, tighten

the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can

result.