Whirlpool WGD9051YW 사용 및 관리 매뉴얼 - 페이지 4
{카테고리_이름} Whirlpool WGD9051YW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9051YW 20 페이지. Electronic dryer
Whirlpool WGD9051YW에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지)
페이지 인쇄WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
flammable on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING: To reduce the risk of fire electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS
before operating this appliance.
This Use and Care Guide covers several different models. Your dryer may not have all the cycles and features described.
USING AUTOMATIC CYCLES
Automatic Cycles automatically match
the cycle setting to the type of load and
adjust drying time for optimal performance.
See the Cycles information on the following
pages for more detail on each cycle.
1. Clean lint screen.
2. Place laundry in the dryer. Shut the door.
3. Press POWER.
4. Select the desired AUTOMATIC cycle.
5. Press and hold START/PAUSE to begin.
Stopping Your Dryer
To stop your dryer at any time
Press POWER.
4
QUICK START GUIDE /DRYER USE
QUICK START GUIDE
WARNING
Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death
or fire.
USING TIMED CYCLES
Use Timed Cycles to set a drying time and
temperature. See the Cycles information on the
following pages for more information.
1. Clean lint screen.
2. Place laundry in the dryer. Shut the door.
3. Press POWER.
4. Select the desired TIMED cycle.
5. Press TEMP until the desired temperature glows.
6. Press and hold START/PAUSE to begin.
Pausing or Restarting
To stop the dryer at any time
Open the door or press START/PAUSE once.
To restart the dryer
Close the door and press and hold START/PAUSE