Whirlpool WGD9371YL 사용 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool WGD9371YL에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9371YL 40 페이지. Installation guide
Whirlpool WGD9371YL에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지)

페이지 인쇄

CYCLE SIGNAL

Use this button to turn the signal indicating the

end of a drying cycle on or off.

CYCLE STATUS INDICATORS

The Cycle Status indicators show the progress of a cycle.

Sensing

The Sensing indicator will light during Auto Cycles to

indicate that the moisture sensor on the dryer is operating.

This indicator will not light during Manual Cycles or options

such as Wrinkle Shield

™

Wet

The load is still wet and/or the cycle just started.

In the Enhanced Touch Up or the Quick Refresh Steam

Cycles (on some models), the Wet indicator comes on after

the water has been sprayed into the drum, 4-5 minutes into

the cycle. The Wet light illuminates until the dryer goes into

Cool Down with 1 minute of time remaining.

Damp

This indicator is used with Auto cycles to show that the load

is partially dried and items that you may wish to hang up or

iron while still damp may removed.

Cool Down

The dryer has finished drying with heat, and is now tumbling

the load without heat to cool it down and reduce wrinkling.

Sensing

Wet

Steam model shown

Control Lock

If the dryer is running:

Press and hold the Cycle Signal button for 3

seconds to lock the controls of the dryer and

avoid an accidental change in cycle options

or settings during a drying cycle. Press and

hold again for 3 seconds to unlock.

To enable the Control Lock feature if the

dryer is off, it is not necessary to press

POWER before activating the Control Lock feature.

Steam

Control Lock

Damp

Cool

Done

Down

Done

This will indicate that the selected cycle has ended and the

load may be removed from the dryer. If the Wrinkle Shield

option has been selected, the dryer may continue to tumble

the load, even if the Done indicator is lit.

Wrinkle Shield

This indicator will light if the Wrinkle Shield

selected and is running. The dryer will continue to tumble the

load for up to 90 minutes after the cycle has ended.

Steam (on some models)

This indicator will light when the Steam function is active.

NOTE: Steam is not available on all models or on all cycles.

Control Lock

This indicator will light when the controls are locked. Press

and hold the Cycle Signal button for 3 seconds to unlock.

Wrinkle

Shield

™

option has been

™