Whirlpool WGD9450WW - 27" Gas Dryer 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} Whirlpool WGD9450WW - 27" Gas Dryer에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9450WW - 27" Gas Dryer 32 페이지. Steam and non-steam electronic gas dryer
Whirlpool WGD9450WW - 27" Gas Dryer에 대해서도 마찬가지입니다: 사양 (8 페이지), 사용 및 관리 매뉴얼 (28 페이지), 치수 (1 페이지)

페이지 인쇄

■

Do not use an exhaust hood with a magnetic latch.

Improper venting can cause moisture and lint to collect

indoors, which may result in:

Moisture damage to woodwork, furniture, paint, wallpaper,

carpets, etc.

Housecleaning problems and health problems.

Plan Vent System

Choose your exhaust installation type

Recommended exhaust installations

Typical installations vent the dryer from the rear of the dryer. Other

installations are possible.

A. Dryer

E. Clamps

B. Elbow

F. Rigid metal or flexible metal vent

C. Wall

G. Vent length necessary to connect elbows

D. Exhaust hood

H. Exhaust outlet

Optional exhaust installations

This dryer can be converted to exhaust out the right side, left side, or

through the bottom. If you prefer, you may contact your local dealer

to have the dryer converted.

A. Standard rear offset exhaust installation

B. Left or right side exhaust installation

C. Bottom exhaust installation

Alternate installations for close clearances

Venting systems come in many varieties. Select the type best

for your installation. Two examples of close-clearance installations

are shown. Refer to the manufacturer's instructions.

A. Over-the-top installation (also available with one offset elbow)

B. Periscope installation

NOTE: The following kits for close-clearance alternate installations

are available for purchase. Please see the "Assistance or Service"

section to order.

■

Over-the-Top Installation:

Part Number 4396028

■

Periscope Installation (For use with dryer vent to wall vent

mismatch):

Part Number 4396037 - 0" (0 mm) to 18" (460 mm) mismatch

Part Number 4396011 - 18" (460 mm) to 29"(737 mm) mismatch

Part Number 4396014 - 29" (737 mm) to 50" (1270 mm)

mismatch

Special provisions for mobile home installations

The exhaust vent must be securely fastened to a noncombustible

portion of the mobile home structure and must not terminate

beneath the mobile home. Terminate the exhaust vent outside.

Determine vent path

■

Select the route that will provide the straightest and most direct

path outdoors.