Whirlpool WGD9500EW 설치 지침 매뉴얼 - 페이지 10

{카테고리_이름} Whirlpool WGD9500EW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9500EW 26 페이지. Gas and electric dryer

MAKE ELECTRICAL CONNECTION -

U.S.A. ONLY (EFFECTUER LE

RACCORDEMENT ÉLECTRIQUE –

ÉTATS-UNIS SEULEMENT)

Power Supply Cord

Electrical Connection Options

Choose electrical connection type

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to Power Supply Cord Connection.

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to Power Supply Cord Connection.

4-wire direct connection:

Go to Direct Wire Connection.

3-wire direct connection:

Go to Direct Wire Connection.

NOTE:

If local codes do not permit connection of a

cabinet-ground conductor to neutral wire, go to "Optional

3-wire connection." This connection may be used with

either a power supply cord or a direct wire connection.

Remove terminal block cover

Remove hold-down screw and terminal block cover.

Power Supply Cord Strain Relief

Attach power supply cord

strain relief

Remove the screws from a 3/4" (19 mm) UL listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole below the terminal block opening

(B) so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

Attach power supply cord

to strain relief

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.