Whirlpool WGD9500EW 설치 지침 매뉴얼 - 페이지 22

{카테고리_이름} Whirlpool WGD9500EW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9500EW 26 페이지. Gas and electric dryer

REVERSE DOOR SWING

Tools needed:

Plastic putty knife

#2 Phillips screwdriver

You can change your door swing from a right-hinge opening

to a left-hinge opening, if desired.

Note:To complete the door swing reversal exactly as seen in

these instructions, a door reversal kit must be purchased. For

ordering information, please reference the "Use and Care Guide."

1. Place a towel or soft cloth on a flat workspace such as a floor

to avoid damaging the dryer's surface or the dryer door.

Remove door from dryer cabinet

1. Open the dryer door.

2. Use a plastic putty knife to remove the hinge covers and

plastic covers from the front panel of the dryer. Set them aside.

3. Using a T20

screwdriver, remove screws (A) and then

screws (B) from each of the 2 hinges attaching the dryer

door to the front panel of the dryer. Set the hinge screws off

to the side for use in reinstalling the door.

Min. 8" long TORX T20

® †

screwdriver

Optional Assembly Kit

Covers

4. Remove the dryer door from the cabinet by lifting upward

and out. Lay the door on a towel or a soft cloth you placed

on a flat workspace.

5. Use a plastic putty knife to remove the door hinge covers.

Set them aside.

6. Using a #2 Phillips screwdriver, remove the remaining 4 screws

from the hinges. Then remove hinges A and B and set both the

screws and hinges aside.

® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.

†