FireplaceXtrordinair 4237 EG 설치
{카테고리_이름} FireplaceXtrordinair 4237 EG에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. FireplaceXtrordinair 4237 EG 4 페이지. Fireback
FireplaceXtrordinair 4237 EG에 대해서도 마찬가지입니다: 설치 (3 페이지)
페이지 인쇄
Compatibility
4237 Fireplace EG (FIREBACKS ARE REQUIRED BEFORE OPERATING THE 4237 EG FIREPLACE)
Packing List
Rear Fireback Panel
Left and Right Side Fireback panels (each side fireback has a small notch at the front of the upper edge)
(4) Front and back - side panel spacers (marked with 1 hole on each end).
(4) Top and bottom - side panel spacers (marked with 2 holes on each end).
(2) Top and Bottom - rear panel spacers (marked with 3 holes on each end).
Rear shelf bracket (rear fireback rests on this bracket)
Installation
WARNING
Turn off gas to the appliance and make sure it is cool prior to conducting service.
Preparing the Fireplace
1. The firebacks should be installed while
finalizing the installation (before
installing the logs). Remove the glass
frame.
2. Use a 1/4" nut driver to remove the (8)
fireback clips inside the firebox. These
clips have keyhole slots that allow them
to be removed without removing the
screws (see illustration to the right).
3. Discard the (2) rear side clips and
tighten the screws to seal the holes in
the firebox.
Page 1 of 4
4237 EG Black Glass Fireback Installation
17602212 - 8/24/21
sku# 96100881
Discard the
lower clips and
tighten screws
Travis Industries, Inc.