Whirlpool WGD96HEAW 설치 지침 매뉴얼 - 페이지 21

{카테고리_이름} Whirlpool WGD96HEAW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD96HEAW 44 페이지. 7.4 cu. ft. duet steam gas dryer with advanced moisture sensing
Whirlpool WGD96HEAW에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 사용 및 관리 매뉴얼 (40 페이지)

페이지 인쇄

1. Installation Requirements

Move the door strike

Using a TORX

T25 screwdriver, remove the 2 screws

securing the door strike to the door frame of the dryer.

Remove the 4 screws above and below the door strike and

set aside for later use. Rotate the strike 180° and attach to

the opposite side of dryer door frame, as shown.

Remove inner door from

outer door

Release tab

Position the door with the inside of the door facing up. Using

a Phillips screwdriver, remove the 13 screws securing the

inner door to the outer door. Lift off the inner door and set

aside.

NOTE: There is a small release tab on each side of the door.

If the inner and outer door do not separate easily, slide a

credit card, putty knife, or similar flat object between the inner

and outer doors at the locations shown to release the tab.

Latch

Using a TORX T25 screwdriver, remove the 3 TORX screws

securing the latch plate and the 5 screws holding the hinge

assembly in place.

Latch

Release tab

Using a TORX T25 screwdriver, reinstall the latch plate and

hinge assembly on the opposite sides from which they were

removed.

Remove hinge and latch

from inner door

Reinstall hinge and latch on

opposite sides

Hinge

Latch