Whirlpool WHD5090GW 사용 및 관리 매뉴얼 - 페이지 20
{카테고리_이름} Whirlpool WHD5090GW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WHD5090GW 35 페이지. Heat pump dryer
페이지 인쇄
3.
Connect ground wire
Connect ground wire (F) (green or bare) of power supply
cord under green external ground conductor screw (A).
Tighten screw.
4.
Connect remaining wires
Connect remaining wires under outer terminal block screws.
Tighten screws, tighten strain relief screws, and fold insulator
over terminal block. Finally, reinsert tab of terminal block cover
into slot at bottom edge of terminal block housing. Secure
cover with the 2 hold-down screws. Now, go to "Level Dryer."
3-Wire Power Supply Cord Strain Relief:
IMPORTANT: Use the strain relief supplied with the dryer.
Attach power supply cord to strain relief
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. Do not further tighten strain relief screws at
this point.
20
F
F
A
3-Wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
3-wire receptacle
(NEMA-type 10-30R)
Spade terminals with
upturned ends
1.
Connect neutral (center) wire
D
C
Connect neutral (center) wire (C) of power supply cord under
center terminal block screw (B). Tighten screw.
2.
Connect remaining wires
Connect remaining wires under outer terminal block
screws. Tighten screws, tighten strain relief screws,
and fold insulator over terminal block. Finally, reinsert
tab of terminal block cover into slot at bottom edge
of terminal block housing. Secure cover with the
2 hold-down screws. Now, go to "Level Dryer."
3 prong plug
Ring terminals
B