Whirlpool WHD5090GW 사용 및 관리 매뉴얼 - 페이지 24
{카테고리_이름} Whirlpool WHD5090GW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WHD5090GW 35 페이지. Heat pump dryer
페이지 인쇄
Level Dryer
1.
Level dryer
Place
level here on
either side
Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture-sensing
system to operate correctly. If forward slope of dryer is
greater than 1" (25 mm), water could run out from front
of filter.
Not Level
2.
Adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and dryer does not rock.
24
Not Level
LEVEL
3.
Plug into a grounded 3 prong outlet
Complete Installation Checklist
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
Check that dryer is level. See "Level Dryer."
Check that you have all of your tools.
Dispose of/recycle all packaging materials.
Check dryer's final location.
Remove any tape remaining on dryer.
Wipe dryer drum interior thoroughly with a damp cloth
to remove any dust.
Read "Using Your Dryer" in "Operating Instructions."
For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on power.
Select a Timed Dry heated cycle and start dryer.
If dryer will not start, check the following:
• Controls are set in a running or ON position.
• Start/Pause button has been pushed firmly and held for
3 seconds.
• Dryer is plugged into an outlet and/or electrical supply.
• Household fuse is intact and tight or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated.
The odor will go away.